GE J2S968 Installation Instructions Manual

Also see for Profile J2S968 SERIES: Owner's manual Installation instructions Dimensions and installation information Owner's manual Owner's manual

Contents

GE J2S968 Installation Instructions Manual Manual pdf 14 page image

INSTALL THE RANGE (CONT.)14Installation InstructionsREPLACE THE OVEN DOORNOTE: The oven door is heavy. You may needhelp lifting the door high enough to slide itinto the hinge slots. Do not lift the door bythe handle.Lift the oven door by placing one handon each side. The door is heavy, so youmay need help. Do not lift the door bythe handle.With the door at the same angle as theremoval position (halfway between theclosed and broil stop position), seat thenotch of the hinge arm into the bottomedge of the hinge slot. The notch of thehinge arm must be fully seated into thebottom of the slot.Open the oven door as far as it will open.Push the hinge locks up against the frontframe of the oven cavity, to the lockedposition.Close the oven door.EDCBA22 REPLACE THE STORAGEDRAWERPlace the drawer rail on the guides.Push the drawer in until it stops.Lift the front of the drawer and push inuntil the stops clear the guides.Lower the front of the drawer and push inuntil it closes.SPECIAL INSTRUCTIONS IF YOU AREHAVING PROBLEMS WHILE REPLACINGTHE STORAGE DRAWERRemove and replace, making sure the powercord is not obstructing the drawer and/or therail is in the guide.Remove and replace, making sure the rail is inthe guide.DCBA23StopBottom edgeof slotHinge inlocked positionNotch of hingesecurely fittedinto bottom ofhinge slotDrawer doesnot closecompletelyDrawerfront paneltipped awayfrom bodysideRear drawersupport is on topof guide rail onthe high sideDrawer front paneltipped to one sideHinge armHinge notchIf Drawer Won’t Close:If Drawer is Crooked:Power cordmay beobstructingdrawerin this areaRear drawersupport isresting on topof guide rail