GE JCBP49 Owner's Manual And Installation Instructions

GE JCBP49 Owner's Manual And Installation Instructions Manual pdf 11 page image

Make sure the clock is set to thecorrect time of day.The Timer is a minute timer only.The Timer does not control ovenoperations. The maximum setting onthe Timer is 9 hours and 59 minutes.11Using the clock, kitchen timer and convenience outlet. www.GEAppliances.caTo Set the ClockThe clock must be set to the correct timeof day for the automatic oven timingfunctions to work properly. The time ofday cannot be changed during a timedbaking or self-cleaning cycle.Touch the CLOCK pad.Touch the number pads.Touch the START pad.To Set the TimerTouch the TIMER pad.Touch the number pads until theamount of time you want showsin the display. For example, to set2 hours and 45 minutes, touch 2, 4and 5 in that order. If you make amistake touch the TIMER pad andbegin again.Touch the START pad.After touching the START pad, SET disappears;this tells you the time is counting down, althoughthe display does not change until one minute haspassed. Seconds will not be shown in the displayuntil the last minute is counting down.When the Timer reaches :00, thecontrol will beep 3 times followedby one beep every 6 seconds untilthe TIMER pad is touched.The 6-second tone can be canceled by followingthe steps in the Special features of your ovencontrol section under Tones at the End of aTimed Cycle.To Reset the TimerIf the display is still showing thetime remaining, you may change it bytouching the TIMER pad, then touch thenumber pads until the time you wantappears in the display.If the remaining time is not in the display(clock, delay start or cooking time are inthe display), recall the remaining time bytouching the TIMER pad and thentouching the number pads to enter thenew time you want.To Cancel the TimerTouch the TIMER pad twice.Convenience Outlet (on some models)The 120V convenience outlet located onthe top of the backguard may be used toplug in small electrical appliances.When using the outlet, be sure that theelectrical cord does not rest on or near asurface unit. If the surface unit is turnedon, the cord will be damaged.To reset the circuit breaker, press theswitch located near the outlet on top ofthe backguard.Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support