32REMOVE STORAGE DRAWERON MODELS WITHOUT BAKINGOR WARMING DRAWERSPull the drawer out until it stops.Lift the front of the drawer until thestops clear the guide.Remove the drawer.CBA4ANTI-TIP DEVICE INSTALLATIONAn Anti-Tip bracket is supplied with instructionsfor installation in a variety of locations. Theinstructions include all necessary informationto complete the installation. Read the SafetyInstructions and the instructions that fit yoursituation before beginning installation.WARNING —• Range must be secured by Anti-Tip bracketsupplied.• If the Anti-Tip device supplied with therange does not fit this application, use theuniversal Anti-Tip device WB2X7909.• See instructions to install (supplied withbracket).• Unless properly installed, the range couldbe tipped by stepping or sitting on the door.Injury may result from spilled hot liquidsor from the range itself.2Installation InstructionsINSTALL THE RANGEStopTypical installation of anti-tip bracket attachment to wallBracketScrew mustenter woodor metalWall plateLEVEL THE RANGEInstall the oven racks in the ovenand position the range where it willbe installed.Check for levelness byplacing a spirit level ora cup, partially filledwith water, on one ofthe oven racks. If usinga spirit level, take tworeadings—with the levelplaced diagonally first inone direction and then the other.The front leveling legs can be adjustedfrom the bottom and the rear legs can beadjusted from the top or the bottom.Use an open-end or adjustable wrenchto adjust the leveling legs until the rangeis level.DCBA5LeglevelerLowerrangeRaiserangeSpirit levelPREPARE TO LEVEL MODELS WITHWARMING DRAWERSMeasure the height of your countertopat the rear of the opening (X).Adjust two rear leveling legs so that therear of the cooktop is at the same heightas the counter (Y).Slide unit into place.CBA3XY