GE JEM31WF - Spacemaker II Microwave Oven Installation Instructions Manual

Also see for JEM31WF - Spacemaker II Microwave Oven: Installation instructions Owner's manual Specification

Contents

GE JEM31WF - Spacemaker II Microwave Oven Installation Instructions Manual Manual pdf 2 page image

TOOLS YOU WILL NEED2Installation Instructions❒ #2 Phillips Screwdriver❒ Tape Measure❒ Drill with 7/64″ Bit or #35❒ Scissors (Optional)❒ Pencil❒ Awl or Punch❒ CUTOUT DIMENSIONSWARNING — This trim kit uses airflow from the top, bottom and sides of thetrim frame. Blocking the air flow can causethe microwave to function improperly andmay cause damage to the microwave.Allow a 1″ clearance beyond the edge of thetrim frame to provide proper air flow.1DepthHeight11⁄2″ OverlapWidth11⁄2″ Overlap1″ Clearancebeyond trim frame(on all sides)3″ Min.27″ Models: 11⁄2″ overlap30″ Models: 3″ overlap❒ CUTOUT DIMENSIONS (CONT.)On 27″ models, allow 1 1⁄2″ on all sides foroverlap of the trim frame over the edges ofthe cutout.On 30″ models, allow 1 1⁄2″ at the top andbottom and 3″ on each side for overlap ofthe trim frame over the edges of the cutout.FOR INSTALLATION ABOVE ABUILT-IN OVEN:Microwave oven should be installed on a 3/8″plywood base and supported by 2x4 or 1x2equivalent runners on all sides. Base must becapable of supporting a minimum of 100 lbs.1* Min. depth with 120V–60 Hertz grounded powerreceptacle outside cabinet 211⁄2″Min. depth with 120V–60 Hertz grounded powerreceptacle inside cabinet 23″Models 27″ 30″Height 18 3⁄4″ 18 3⁄4″Width 24″ ± 1⁄16″ 24″ ± 1⁄16″Depth (min.)* 21 1⁄2″ or 23″ 21 1⁄2″ or 23″❒ INSTALL THE ANTI-TIP BRACEDraw a line on the cutout floor at thecenter of the cutout, and extend the line1/2″ down the face of the cabinet.Fold or cut the front edge of the template,along the front guide line. Place thetemplate flush along the front edge of thecutout floor, aligning the center line ofthe template with the center line of thecutout floor. Mark the centers of the twoscrew holes with an awl or center punchfor the anti-tip brace location as shown.Remove thetemplate and drilltwo holes for theanti-tip brace.Install the anti-tipbrace onto thecutout floor usingtwo round-headscrews.DCBA2Round-HeadScrewsAnti-TipBraceCutoutFloorCenterLineB ACDIMENSIONS:A = 13⁄16″B = 3″C = 201⁄16″❒ Level

/ 4

Related manuals for GE JEM31WF - Spacemaker II Microwave Oven