GE JGBP33SEMSS Owner's Manual & Installation Instructions

Also see for EGR2000: Owners and installation manual Owner's Manual & Installation Instructions Owner's manual and installation instructions Owner's Manual & Installation Instructions Owner's Manual & Installation Instructions

GE JGBP33SEMSS Owner's Manual & Installation Instructions Manual pdf 33 page image

33ge.comWire cover holder.Oven ShelvesClean the shelves with an abrasive cleanseror scouring pad. After cleaning, rinse theshelves with clean water and dry with aclean cloth.If the shelves ever become hard to slide,wipe the shelf edges or oven shelf supportswith vegetable oil.NOTE: Take the shelves out of the oven before youbegin the self-clean cycle or they may discolor.Oven Light ReplacementCAUTION: Before replacing youroven light bulb, disconnect the electrical power tothe range at the main fuse or circuit breaker panel.Be sure to let the light cover and bulb coolcompletely.The oven light bulb is covered with aremovable glass cover that is held in placewith a bail-shaped wire. Remove the ovendoor, if desired, to reach cover easily.To remove:Hold a hand under the cover soit doesn’t fall when released. Withfingers of the same hand, firmlypush back the wire cover holder.Lift off the cover.Do not remove any screws to removethe cover.Do not touch hot bulb with a wetcloth. Replace bulb with a 40-watthousehold appliance bulb.To replace cover:Place it into the groove of the lightreceptacle. Pull the wire forward to thecenter of the cover until it snaps intoplace. When in place, the wire holdsthe cover firmly. Be certain the wireis in the depression in the center ofthe cover.Connect electrical power to the range.OperatingInstructions Care and Cleaning InstallationInstructions Troubleshooting TipsSafety Instructions Consumer Support