GE JGBS02 Owner's Manual & Installation Instructions

Also see for Appliances JGBS04: Owner's Manual & Installation Instructions Owner's Manual & Installation Instructions Owner's manual and installation instructions Owner's Manual & Installation Instructions Owner's Manual & Installation Instructions

GE JGBS02 Owner's Manual & Installation Instructions Manual pdf 10 page image

When the timer is counting down, use the + and –pad to change the remaining time, or press theTIMER ON/OFF pad to stop the timer. The timercannot be cancelled unless you have fully completed“set timer” instructions above.Pressing the CLOCK pad while the timer is operatingwill not interfere with the timer’s operation; thedisplay will change to show the clock, but the timerwill continue to count down and will still signal whentime is up. Press the TIMER ON/OFF pad again tochange the display back to show the timer.10CLOCK AND TIMER(on some models)You have the choice of having the timer show thetime counting down or the time of day. In either case,the timer will signal at the end of the timer period toalert you that the time is up.(appearance may vary)To Change or Cancel the Timer Setting Display Clock While Timer Is OperatingTo Set the ClockNOTE: When you first plug in the range or after apower failure, the entire Clock/Timer display will light up.1. Press the CLOCK pad.2. Press and hold the + or – pad and thetime of day will change 10 minutes at atime. To change the time by singleminutes, give the pads short taps.3. Press the CLOCK pad to start theclock.To Set the Timer1. Press the TIMER ON/OFF pad.2. Use the + and – pads to set the timer.Short taps on the + or – pad change thetimer’s setting one minute at a time.Pressing and continuing to hold the +pad increases the setting ten minutes ata time.3. Once you have set your timer, press the TIMERON/OFF pad to start timing.As the timer counts down, a signal will indicatewhen one minute is left. After this signal, the displaywill count down in seconds. When time runs out, afinal signal will sound. Press the TIMER ON/OFFpad to stop the signal.