!Insta"ationIOasS"0e'nnstructlons JGSP28I_ Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: www.GEAppliances.com IIN THE COMMONWEALTH OFMASSACHUSETTS:• This product must be installed by alicensed plumber or gas fitter.• When using ball-type gas shut-off valves,they shall be the T-handle type.• A flexible gas connector, when used, mustnot exceed 3 feet.BEFORE YOU BEGINRead these instructions completelyand carefully.• IMPORTANT --Savetheseinstructions for local inspector's use.• IMPORTANT -Observeallgoverning codes and ordinances.• Note to Installer - Be sure to leave theseinstructions with the Consumer.• Note to Consumer - Keep theseinstructions for future reference.• Product failure due to improper installationis not covered under the Warranty.-&WARNING -This appliance mustbe properly grounded.• IMPORTANT - Leak testing of theappliance shall be conducted according tothe manufacturer's instructions.• Proper installation is the responsibilityof the installer and product failure due toimproper installation is NOT covered underwarranty.PARTS INCLUDEDRear Filler2 ScrewsScrews Anti-Tip BracketMATERIALS YOU MAY NEED/Joint Sealant Shut Off ValvePipe FittingsCSA-Approved Flexible Gas Line3/8" Min. ID, 1/2" NPT Connection,3-foot Maximum Length (Massachusetts Only)TOOLS YOU WiLL NEED1/4" Nut Driver LevelPhillips HeadScrewdriverPipe WrenchTape MeasureSafety GlassesWrench or Pliers(for 1-7/16" Nut)Drill31-10598-1 (11-04 JR) 1