I Ilnstallation I Gas Slide-In Rangelnstructions JGS905, JGS968, PGS968Ir_ Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.comIn Canada, call 1.800.361.3400 or Visit our Website at: www.geappliances.ca IIN THE COMMONWEALTH OFMASSACHUSETTS:• This product must be installed by alicensed plumber or gas fitter.• When using ball-type gas shut-off valves,they shall be the T-handle type.• A flexible gas connector, when used, mustnot exceed 3 feet.PARTS INCLUDEDScrewsRear Filler2 ScrewsAnti-Tip BracketBEFORE YOU BEGINRead these instructions completelyand carefully.• IMPORTANT - Savetheseinstructions for local inspector's use.• IMPORTANT - Observeallgoverning codes and ordinances.• Note to Installer - Be sure to leave theseinstructions with the Consumer.• Note to Consumer - Keep theseinstructions for future reference.• Product failure due to improper installationis not covered under the Warranty.-&WARNING - This appliance mustbe properly grounded.• IMPORTANT - Leak testing of theappliance shall be conducted according tothe manufacturer's instructions.• Proper installation is the responsibilityof the installer and product failure due toimproper installation is NOT covered underwarranty.MATERIALS YOU MAY NEEDJoint Sealant Pipe Fittings Shut Off ValveCSA-Approved Flexible Gas Line3/8" Min. ID, 1/2" NPT Connection,3-foot Maximum Length (Massachusetts Only)TOOLS YOU WILL NEED1/4" Nut DriverPhillips HeadScrewdriverTape MeasureSafety GlassesLevelPipe WrenchWrench or Pliers(for 1-7/16" Nut)Drill31-10665 10-07 JR1