To Operate —Vents(“JN” models only)Lamp switch Fan switch TrimLamp Switch Models: JN322, JV322 & JV332Press for OFF and ON.Lamp Stitch All other models.CENTER position OFF, LE~ position NIGHT LIGHT,RIGHT position BRIGHT LIGHT.Fan SwitchCENTER position OFF, LEFT position LOW SPEED,RIGHT position HIGH SPEED.To MaintainReplaceable Filter ‘6JN” models onlyThe efficiency of your hood depends upon a clean filter.The frequency of filter replacement depends on the typeof cooking you do; however, with average, normalusage, replacement should be every 6 to 12 months.NEVER OPERATE THE HOOD WITHOUT THEFILTER IN PLACE.When to replace the filter: The filter has distinct colorstripes of indicating material on the visible surface. It isTIME TO CHANGE when the stripes have eitherblended together or faded completely.To remove: Turn the retaining clip to release the front ofthe filter. The filter will then slip out of the retaining tabson the back.To replace: Slip the back edge into the retaining tabsand lock in place with the retaining clip.Replace with genuine GE part: filter part numberWB02X8253 (JN322) or WB02X8254 (JN334, JN335,JN634, JN635).Grease Filter “JV” models onlyThe efficiency of your hood depends on a clean filter.Frequency of cleaning depends on the type of cooking youdo. BUT GREASE FILTER SHOULD BE CLEANEDAT LEAST ONCE A MONTH. NEVER OPERATETHE HOOD WITHOUT THE FILTER IN PLACE.To remove: Turn the retaining clip to release the edge ofthe filter. The filter will then slip out of the retaining tabs.To clean: Soak and then agitate in a hot detergentsolution. Light brushing may be used to remove irnbeddedsoil. Rinse, shake and remove moisture before replacing.With careful handling, the filter will last for yean. Ifreplacement becomes necessary, order the part from yourdealer.To replace: Slip the edge into the retaining tabs and lockin place with the retaining clip.HoodClean grease laden surfaces of the hood frequently.Use warm detergent solution. About 1 tablespoon ofammonia may be added to the water. TAKE CARE TONOT COME IN CONTACT WITH FILTERS ANDOTHER NON-ENAMELED SURFACES. The hoodshell can be washed, rinsed and dried with a soft cloth.CAUTION: Be certain when cleaning the hoodsurfaces you do not touch the lamp bulb with moisthands or cloth. A warm or hot lamp bulb may breakif touched with a moist surface. ALWAYS let lampcool COMPLETELY before cleaning around it.Motor and FanTo Clean Motor and Fan1. DISCONNECT THE HOOD POWER SUPPLY ATTHE HOUSEHOLD DISTRIBUTION PANEL BYREMOVING THE FUSE OR SWITCHING OFFTHE CIRCUIT BREAKER.2. Remove the filter.3. Wipe the fan blade and motor with cloth, dampenedonly in ammonia and warm water solution.4. Replace the filter.5. Reconnect the hood power supply.U.L. RequirementWARNING: THE ELECTRICAL WIRING ANDFAN MOTOR IN THIS RANGE HOOD ARE NOTINTENDED FOR USE WITH, OR PROVIDEDWITH A SOLID STA~ SPEED CONTROL. ANYSUCH ALTERATION FROM ORIGINALFACTORY WIRING CONCEPT COULD RESULTIN DAMAGE TO THE UNIT AND/OR CREATEAN ELECTRICAL SAFETY HAZARD.3.