GE JNM3161RFSS Installation Instructions Manual

Also see for AVM4160DFBS: Use and care manual Dimensions and installation information

GE JNM3161RFSS Installation Instructions Manual Manual pdf 21 page image

21 Remove the blower motor screws that holds the blowerplate to the microwave oven. Slide the plate toward theback of the microwave and lift up to remove.ADAPTING BLOWER FOROUTSIDE BACK EXHAUSTC4Remove screw on the back of the unit.21USE TOP CABINET TEMPLATEFOR PREPARATION OF TOPCABINETC3 Read the instructions on the TOP CABINETTEMPLATE. Tape it underneath the top cabinet. Drill the holes, following the instructions on theTOP CABINET TEMPLATE.CAUTION::HDUVDIHW\JRJJOHVZKHQGULOOLQJKROHVLQWKHFDELQHWERWWRPWallMountingPlateSpacing for Toggles MoreThan Wall ThicknessToggleBoltToggle Wings7RXVHWRJJOHEROWVBoltEndInstallation InstructionsYou need to drill holes for the top support screws anda hole large enough for the power cord to fit through.Place the mounting plate against the wall and insertthe toggle wings into the holes in the wall to mountthe plate.NOTE: Before tightening toggle bolts and wood screw,make sure the tabs on the mounting plate touchthe bottom of the cabinet when pushed flush againstthe wall and that the plate is properly centered underthe cabinet.CAUTION:%HFDUHIXOWRDYRLGSLQFKLQJILQJHUVEHWZHHQWKHEDFNRIWKHPRXQWLQJSODWHDQGthe wall.Tighten all bolts. Pull the plate away from the wallto help tighten the bolts.34Blower PlateBlower Motor ScrewsThe fan needs to be turned 180 degrees to the rightto be in the correct orientation, keeping the blowerpart of the fan where the air comes out at the topof the fan. The wire needs to be reinsterted into thecage housing once it has been oriented correctly.4Back of MicrowaveFan BladesWires3ATTACH THE MOUNTING PLATETO THE WALL contC2ScrewCarefully remove fan from cavity. Remove the wirefrom the notch at the bottom of the fan after it isremoved from the cavity.5 Remove the knockout plates in the back of the unitwith snips.Back of mircrowaveKnockout Plates:Snip all 4 webs oneach knockout paneland remove the metalknockouts for rear airflow.Please take care toremove any sharp edgescreated from removingthe knockout plates.