10INSTALLATION INSTRUCTIONSElectrical RequirementsCAUTION: FOR PERSONAL SAFETY,REMOVE HOUSE FUSE OR CIRCUITBREAKER BEFORE BEGINNINGINSTALLATION.This appliance must be supplied with the propervoltage and frequency and connected to anindividual, properly grounded branch circuit,protected by a circuit breaker or time delay fuse,as noted on the rating plate.All wire connections must be made inaccordance with local codes and properlyinsulated. Check with your local utility forgoverning electrical codes and ordinances.In the absence of local electrical codes, theNational Electrical Code, ANSI/NFPA No.70–Latest Edition, governing electric rangeinstallations, must be followed.A copy of the National Electrical Code can beobtained by writing to:National Fire Protection AssociationBatterymarch ParkQuincy, MA 02260If you fail to wire your counter unit inaccordance with governing codes, youmay create a hazardous condition.CAUTION: The electrical power to thecounter unit supply line must be shut offwhile line connections are being made.Failure to do so could result in seriousinjur y or death.Before You BeginRead these instructions completelyand carefully.IMPORTANT—Save these instructionsfor local inspector’s use.IMPORTANT—Obser ve all governing codesand ordinances.NOTE TO INSTALLER—Be sure to leavethese instructions with the Consumer.NOTE: This appliance must be properlygrounded.Tools You Will Need• 1/8″ Drill bit• Electric or hand drill• Flat blade screwdriver• Pencil• Ruler or tape measure and straightedge• Hand saw or saber saw