GE JP938 Technical Service Manual

Also see for JP350: Installation instructions Owner's manual Installation instructions Owner's manual Owner's manual

GE JP938 Technical Service Manual Manual pdf 23 page image

– 21 –GEA00817Mark NumbersMark NumbersNext to TabsMark NumbersNext to Tabs3. Lift the burner off the springs and mark thenumbers on the bottom of the burner next to thetabs.4. Remove the tabs and install them on the newburner in the same numbered position.Note: When installing the new burner, make surethe 2 springs are on the 2 posts.ELECTRONIC MODELSWARNING: Before servicing the cooktop,power must be removed from the cooktop bypulling the plug out of the outlet or turning thepower off at the circuit breaker.Glass and Cooktop Removal fromCountertopNote: The ceramic glass and touch board shall besupplied as a complete assembly.1. Remove all cooktop hold-down retainers frombelow the edge of the countertop.2. Protect the counter with two strips of wood orcardboard as shown below.3. Reach up from inside the cabinet and pushupward on the bottom of the burner box enoughto shim with protective wood or cardboardunder one end. Repeat for the other end.Caution: Screws on the bottom of the burner boxcan scratch the countertop surface. Use care toprotect the countertop appearance.GEA008474. Using the shims to get a handhold under the leftand right sides of the glass, carefully raise thecooktop up about 4 in., rotate slightly left orright (to the best working advantage), and setdown as shown. Lift each end slightly andadjust the wood or cardboard to preventscratching the countertop.5. Remove all screws from along the top edge onall 4 sides of the burner box and slowly lift thefront of the glass off the burner box.Remove these screws