GE JSP39SN4SS Owner's Manual

Contents

GE JSP39SN4SS Owner's Manual Manual pdf 35 page image

Storage draweris crookedGEAppliances.comPossible CausesRear drawer support ison top of the guide rail.What To Do• Reposition the drawer. See the Storage DrawerRemova! instructions in the Care and cleaningof the range section.Storage drawerwon't closePower cord mag beobstructing drawerin the lower backof the range.• Repositionthe drawer and power cord. SeetheStorage Drawer Removal instructions in the Careandcleaning of the range section.Rear drawer support ison top of the guide rail.• Reposition the drawer. See the Storage DrawerRemoval instructions in the Care and cleaning of therange section.=Oven will not self-clean The oven temperature is • Allowthe oven to cool to room temperature andtoo high to set a self-clean reset the controls.operation.Oven controls impropedg set. • See the Using the self-cleaning oven section.Oven door is not in the locked • Hake sure Sou move the door latch handle all theposition, wag to the right."Crackling" or This is the sound of the • This is normal."popping" sound metal heating and coolingduring both the cooking andcleaning functions.Excessive smoking Excessive soil. • Touch the Clear/Off pad. Open the windows toduring a clean cgcle rid the room of smoke. Wait until the light on theSelf Clean pad goes off. Wipe up the excess soil andreset the clean cycle.Oven door will not Oven too hot. • Allow the oven to cool below locking temperature.unlockOven not clean after Oven controlsnot properlg set. • Seethe Using the self-cleaning oven section.a clean cgcle Oven was heavilg soiled. • Clean up heavg spillovers before starting the cleancgcle. Heavilg soiled ovens mag need to self-cleanagain or for a longer period of time."F-" and a number You have a function • Disconnect all power to the range for at leastor letter flash error code. 50 seconds and then reconnect power. If the functionin the display error code repeats, call for service.• On self-cleaning models, if a function error codeappears during the self-cleaning cgcle, check the ovendoor latch. The latch mag have been moved, if onlgslightlg, from the locked position. Hake sure the latchis moved to the right as far as it will go. Touch theClear!Off pad. Allow the oven to cool for one hour.Putthe oven back into operation.Water remaining on This is normal.oven floor after SteamClean cycle• Remove ang remaining water with a drg clothor sponge.55