GE JVB94 Owner's Manual And Installation Instructions

Also see for JVB37: Owner's Manual & Installation Instructions Owner's Manual & Installation Instructions Owner's Manual & Installation Instructions Owner's manual and installation instructions Owner's Manual & Installation Instructions

Contents

Installation instructions[] CONNECT THE POWERPlug power cord into a properly groundedreceptacle.INSTALL THE COOKTOPWith the downdraft in the "down" position,place the cooktop into the cutout.Push the cooktop back until the back edgeof the cooktop just barely touches the frontedge of the downdraft cover.Using a dime as a thickness gauge, alignthe cooktop so that there is a minimumuniform gap of 0.05" (the thickness ofa dime) between the cooktop and thedowndraft cover.NOTE: Do not force the downdraft cover tomove rearward when aligning the cooktop.This may cause the downdraft cover toimpact and damage the cooktop when thevent is raised and lowered.NOTES:* Accurate alignment of cooktop anddowndraft is necessary to ensure that thereis no interference when air vent is raisedand lowered. There should be a gap of0.05" (the thickness of a dime) between theback edge of the cooktop and the frontedge of the downdraft cover.* Radiant cooktop cannot be flush mountedwhen using this downdraft vent.OPTIONAL KITSJXRB67 optional accessory for indoor remotelocation of the blower/motor assembly. Usethis kit when the blower and motor assemblywill be located below the cabinet floor.MOL !ingbracketsJXBC67 optional outdoor cover accessoryfor remote installation of blower and motorassembly on an outside wall.k J17

/ 20

Related manuals for GE JVB37