Installation instructionsRECIRCULATINGiNSTALLATiON OVERVIEWC1. Attach Mounting Plate to WallC2. Prepare Top CabinetC3. A(0 ust BlowerC4. Mount the OvenC5. Install Charcoal Filter (not supplied)(Non-Vented Ductless)ATTACH THE MOUNTINGPLATE TO THE WALLAttach tile plate to the wall using toggle bolts. Atleast one wood screw must be used to attach tileplate to a wall stud.[]Remove tile toggle wings f_om the bolts.[]Insert the bolts into tile mounting plate throughthe holes designated to go into drywall andreatmch the toggle wings to ¾" onto each bolt.To use toggle bolts:Spacingfor TogglesMoreThanWall-_l_i_--ThiclWingsMountingPlateBolt End_ Place the mounting plate against the wall andinsert the toggle wings into tile boles in tile wallto I'tlOllllt the plate.NOTE: Before tightening toggle bolts and woodscrew, make sure the robs on the mounting platetouch the bottom of the cabinet when pushed flushagainst tile wall and that tile plate is properlycentered under the cabinet.CAUTION: Be careflfl to avoid pinching fingersbetween the back of tile mounting plate and tile wall._ Tighten all bolts. Pull the plate away from tile wallto help tighten tile bolts.USE TOP CABINET TEMPLATEFOR PREPARATION OF TOPCABINETYou need to drill boles for the top support screws anda hole large enough for the power cord to fit through.* Read the instructions on the TOP CABINETTEMPI ATE.* Tape it underneath the top cabinet.o Drill the boles, fbllowing the instructions on theTOP CABINET TEMPLATE.CAUTION: Wear safeb_ goggles when drilling bolesin the cabinet bottom.19