GE JVM1540 Installation Instructions Manual

Also see for Spacemaker HVM1540: Owner's manual Owner's manual Owner's manual Installation instructions User guide

Contents

GE JVM1540 Installation Instructions Manual Manual pdf 8 page image

Installation InstructionsI PLACEMENT OF THE MOUNTING PLATEREMOVING THE OVEN FROMTHE CARTON/REMOVING THEMOUNTING PLATE%[]Remove the turntable, installation instructions,filters, exhaust adaptoi; dampe_; shelf and thesmall hardware bag. Do not remove the Styrofoamprotecting the flont of the oven.Fold back all 4 carton flaps flflly against cartonsides. Then careflflly roll the oven and carton overonto the top side. The oven should be resting inthe Styrofoam.[]Pull the carton lap and off the oven.[] The mounting plate is attached to the back of theoven. Remove the two screws holding it to the oven.The plate will be used as the rear wall template andfor mounting the oven to the wall.[] Set the oven upright. Remove and properly discardplastic bags and Styrofoam.Open tim oven door and remove any packingmaterial, if present, from inside the oven.I-_ FINDING THE WALL STUDSl iWallStudsiCentesimi_i_ Find the studs, using one of the followingmethods:A. Stud finder - a magnetic device whichlocates nails.ORB. Use a hammer to tap lightly across themounting surface to find a solid sound.This will indicate a stud location.After locating the stud(s), find the center byprobing the wall with a small nail to find theedges of the stud. Then place a mark halfk,vaybetween the edges. The center of any adjacentstuds should be 16" or 24" fiom tiffs mark._Draw a line down the center of the studs.THE OVEN MUST BE CONNECTED TO AT LEASTONE WALL STUD.8