GE JVM1660CB007 Installation Instructions Manual

Contents

Installation InstructionsADAPTING MICROWAVEBLOWER FORRECIRCULATION (cont.)]Place tile blower unit back into tile opening.CAUTION: Do not pull or stretch the blower unitwiring, Make sure the wires are not pinched,]Secure blower unit to microwave with the screwremoved in Step 4.[]Replace blower plate with the screw removed inStep l.Ti_.___ BackofMicrowaveI-_ MOUNT THE MICROWAVEOVENFOR EASIER INSTAI,I,ATION AND PERSONALSAFETY, WE RECOMMEND THAT TWO PEOPLEINSTALL THIS MICROWAVE OVEN.IMPORTANT: Do not grip or use handleduring installation.NOTE: If your cabinet is metal, use the nylongrommet around the power cord hole to preventcutting of the cord.NOTE: We recommend using fillet blocks if thecabinet flont hangs below the cabinet bottom shelf.IMPORTANT: If filler blocks are not used,case damage may occur from overtighteningscrews.NOTE: When mountingtile microwave oven,thread power cordthrough hole in bottom oftop cabinet. Keep it fightthroughout Steps 1-3. Donot pinch cord or liftoven by pulling cord.[]Lift microwave, tilt itforward, and hookslots at back bottomedge onto four lowertabs of mounting)late._ Rotate flont of ovenup against cabinetbottom._ Insert a self-aligning screw through top centercabinet hole. Temporarily secure the oven byturning the screw at least two full turns after thethreads have engaged. (It will be completely6ghtened later.) Be sure to keep power cordtight. Be careful not to pinch the cord, especiallywhen mounting flush to bottom of cabinet.CabinetFrontCabinetBottomShelfFillerBlock-3_oEquivalentto Depthf CabinetRecessSelf-AligningScrewMicrowaveOvenTop_Attach the microwave oven to the top cabinet.21