GE Match User Manual

Also see for Match: User manual

Contents

LX: OPM_MAE_XXX_2K2_3K0_XGB_V020 2 GE DE Match 2200-3000: user manual 2.0 (GB)GE Digital Energyg1.1 IntroductionThe GE (General Electric) Digital Energy Match UPS, an uninterruptible power supply, protects yourequipment from all forms of power interference, including complete power failures.1.2 Safety Rules! CAUTION: RISK OF ELECTRICAL SHOCK. After installation, the UPS system (UPS +battery pack) contains batteries. The appliance outlets may be electrically live, even whenthe UPS is disconnected from the mains.! The UPS contains potentially hazardous voltages. Do not open the UPS, there are no userserviceable parts inside.! All maintenance and service work, including replacement of the batteries, should beperformed by qualified service personnel.1.3 Transport / Storage! No liability can be accepted for any transport damage when the equipment is shipped in non-original packaging.! Store the UPS in a dry location with the batteries in a fully charged state. Storage temperaturemust be within -20 +45 "C. If the unit is stored for a period exceeding 3 months, optimal batterylifetime is obtained if the storage temperature does not exceed 25°C.! If the unit is stored for an extended period of time, the batteries must be recharged periodically.Connect the battery pack to the UPS. Subsequently connect the unit to a wall outlet and rechargethe batteries for 24 hours:- if the storage temperature is within -20 and +30°C: every 3 months,- if the storage temperature is within -20 and +45°C: every month.The shipment contains a Match UPS, a battery pack, one mains power cord, two IEC male-female outputcords, a data cable, a CD ROM and this manual. After unpacking, inspect the UPS for damage. If anydamage is present please immediately notify the carrier and place of purchase.IMPORTANT:Before making any connection and switching on the UPS, please check the following conditions:! your mains supply is 220 - 240 Volts and 50 or 60 Hz, and! the total power demand of the connected equipment does not exceed the rated output power ofthe UPS (indicated on the rating label) (7, fig. 1).2.1 Installation Rules! The UPS is intended to be used in normal domestic and office situations.! Protect the UPS, according to the wiring rules, with a 16A D-type fuse.! The UPS must be powered from a single phase grounded wall outlet. Do not use extensioncords.! Avoid locations that are excessively humid, near water, near heat sources or in direct sunlight.! The ambient temperature should not exceed 40"C. Optimal battery lifetime is obtained if theambient temperature does not exceed 30"C.! If you stack the UPS and its battery pack, always place the UPS on top.! It is important that ventilation air can move freely around and through the unit. Do not block the airvents.! Do not plug appliances such as electric heaters, toasters and vacuum cleaners into the UPS.! Be careful when connecting laser printers: be sure that the demanded power does not exceed thecapacity of the UPS.! The sum of the leakage currents of the UPS and the connected loads should not exceed 3.5mA.1 - Introduction2 - Installation