GE Model 42 Owner's Manual And Installation Instructions

Also see for Outdoor cooking center 48: Owner's manual Use and care guide Owner's manual Owner's manual Installation instructions

Contents

GE Model 42 Owner's Manual And Installation Instructions Manual pdf 14 page image

Replacing the light bulbs.Setting the controls to OFF does not remove power to the light circuit........................................................................................Refrigerator Compartment--Upper Light(appearance may vary)@ Raise tile gl_ille panel, set tile masterpower switch to tile 0 (off)position andallow lamps to cool.@ To x'emove the light shield, press on thesides of tile shield and pull down.@ Replace tile bulbs with appliance bulbsof the same or lower wattage. Replacethe shield by engaging the bottom tabinto tile slot and aI)plying light torwardpressure/mtil tile shield snaps in place.@ Set tile master power switch h) tile I (On)position and close tile grille panel.Refrigerator Compartment--Lower LightThis hght is located above the top drawe_@ Raise tile gl_ille panel, set tile masterpower switch to tile 0 (Off)position andallow lamps to cool.Remove items flxm_ tile shelf above tilelight shield. Remove the shel£Use both hands to grasp each end ofthe light shield. Press in on the bottomof the shield with your thumbs whilerotating tile cover up and out.Replace tile bull) with an appliancebulb of tile same or lower wattage.Replace tile shield by engaging tilebottoln tab into tile slot and appl)inglight forward pressm'e tmtil tile shieldsnaps in place.O Set tile inaster power switch to tile I (Oil)position and close tile grille panel.Freezer Compartment@ Raise tile grille panel, set tile masterpower switch to tile 0 (Of) position andallow lamps to cool.@ Reinoxe tile items ti'()m tile shelf justbelow the light shield. Remoxe theshel£@ To remoxe tile light shield, press downon the top of the shield and pull thetabs out of the slots. Tilt the shieldfi)rward and out.Replace tile bull) with an appliancebulb of the same or lower wattage,and reinstall the light shield. Replacethe shield by engaging the bottom tabinto tile slot and apI)lying light forwardpressm'e tmtil tile shield snaps in place.O Set tile master power switch to tile I (on]position and close tile grille panel.Dispenser@ Raise tile grille panel, set tile masterpower switch to the 0 (off} position andallow lamps to cool.@ Tile bulb is located in tile dispensertrader the control panel. Remove thetwo screws fl'om the light shield. Slidethe light shield toward the dispenser todisengage the tabs, then remove thelight shield. Remove the light bulb b vturning it co/mterclockwise.Replace tile bulb with a bulb of tilesame size and wattage. Replace thelight shield by sliding the tabs intothe slots in the fl'ont of the dispenser.Replace the two screws.@ Set tile master power switch to tile I (0/1)position and dose tile grille panel.14