GE Monogram 49-80565 Owner's Manual

Contents

8Questions?Use thisproblemsolver!PROBLEM POSSIBLE CAUSEFAN AUTOMATICALLY • The Sensor feature will automatically turn the fan on at theTURNS ON AND CAN MED setting if cooking temperatures become too hot. The fanNOT BE TURNED OFF will stay on for a minimum of 3 minutes and will then turn off whentemperatures cool to an appropriate level.FAN DOES NOT • A fuse may be blown or a circuit breaker tripped. Replace fuse orOPERATE WHEN reset circuit breaker.TURNED ON • The power disconnect switch inside the hood may be switched off.Remove the metal grease filters and flip the switch on.FAN FAILS TO CIRCULATE • Check to be sure the metal grease filters are clean. Clean the metalAIR OR MOVES AIR grease filters (see the Metal grease filters section). If cleaningSLOWER THAN NORMAL the filters does not correct the problem, call for service.FAN KEEPS GOING • The motor is probably overheating and turning itself off. This canOFF AND ON be harmful to the motor. Check to be sure the filters are clean. If offand on cycling continues, call for service.LIGHT WILL NOT STAY • Use 120 volt, 50 watt halogen bulbs with a GU10 base and make sureON HIGH SETTING they are inserted securely. See the Light bulbs section.THE HOOD CONTROLS • Disconnect power to the hood by removing the fuse or turning theARE NOT OPERATING circuit breaker off in the home fuse box. Wait 30 seconds to allow theCORRECTLY hood controls to reset and then replace the fuse or move the circuitbreaker back on.SEQUENTIAL PRESSES • It is normal for the light and fan buttons to cycle around through theOF THE LIGHT OR FAN settings so that you can easily set the controls to the desired setting.BUTTONS WILLSOMETIMES CHANGETHE SETTING FROM THELOWEST SETTING–TO OFF–TO THE HIGHEST SETTING,OR FROM THE HIGHESTSETTING–TO OFF–TO THELOWEST SETTINGWHEN PRESSING THE • For your convenience, it is normal for the lights and fan to rememberPOWER ON/OFF BUTTON their last setting when you press the Power On/Off button. If youTO TURN ON THE LIGHT, want only the lights on, press the “FAN +” (or the “FAN –” ) button untilTHE FAN COMES ON the fan is off. When you power the hood up next time, only the lightsINSTEAD will function.The Problem SolverCustom Hood Insert