GE Monogram ZBD4900YSS Dimension Manual

Revised 7/97Monogram.™ULRListed byUnderwritersLaboratoriesFor answers to your GE Monogram,™ GE Profile,™GE, Hotpoint and RCA appliance questions, callGE Answer Center® service, 800.626.2000.ZBD4900YSS—Stainless Steel Professional DishwasherDimensions and Specifications (in inches)Design Information: This dishwasher provides astainless steel appearance, both inside and outside.A toekick is supplied and may be covered with acustom toekick to match kitchen decor.Side trim is not required. Side filler strips are suppliedto fill a 24" wide opening.Additional Specifications: A 120 Volt, 60 Hz powersupply is required. An individual properly groundedbranch circuit protected by a 15 or 20 amp circuitbreaker or time delay fuse is recommended. Install a3-prong electrical receptacle at least 6" above thefloor and within 18" of the right or left adjacentcabinet wall. Wiring must enter the cutout in shadedarea shown. A double, side-by-side installationrequires two separate circuits.The hot water line must enter the cutout in the shadedarea from the right, left, rear or through the floor. Thewater line should be 3/8" O.D. copper or 1/2" O.D.plastic. Installation of an easily accessible handshut-off valve is strongly recommended.The dishwasher should be placed no more than 10 feetfrom the sink for proper drainage.If the dishwasher is to be located in or near a cornerof base cabinets, allow 2" min. clearance from thecorner to prevent interference with adjacent doorhandles.23 3/8"4"5 1/2"34" Min.35" Max.Toekick25 1/4"From InsideFront Frame22 5/8"3 3/16"24"1-3/4" Min.6"Plumbing and Electric ServiceMust Enter Inside This Area34" Min.35" Max.Underside ofCountertopto Floor23-5/8" Min.24" Max.This Wall AreaMust be Free ofPipes or Wires

/ 2

Related manuals for GE Monogram ZBD4900YSS