BEFORE YOU BEGINRead these instructions completely and carefully.• IMPORTANT — Save these instructionsfor local inspector’s use.• IMPORTANT — Observe all governingcodes and ordinances.• Note to Installer – Be sure to leave theseinstructions with the Consumer.• Note to Consumer – Keep these instructions forfuture reference.• Product failure due to improper installation is notcovered under the Warranty.WARNING — This appliance must beproperly grounded.• IMPORTANT — Leak testing of theappliance shall be conducted according to themanufacturer’s instructions.• Proper installation is the responsibility of theinstaller and product failure due to improperinstallation is NOT covered under warranty.FOR YOUR SAFETY:WARNING — If the informationin this manual is not followed exactly, a fire,explosion or gas leak may result, causingproperty damage, personal injury or death.Do not store or use gasoline or otherflammable vapors and liquids in thevicinity of this or any other appliance!WHAT TO DO IF YOUSMELL GAS:• Do not try to light any appliance. Do not touchany electrical switch; do not use any phone inyour building.• Immediately call your gas supplier from aneighbor’s phone. Follow the gas supplier’sinstructions.• If you cannot reach your gas supplier, call the firedepartment.Installation and service must be performed bya qualified installer, service agency or the gassupplier.WARNING — Disconnect all electricalpower at the main circuit breaker or fuse boxbefore installing.This cooktop has been design certified by UnderwritersLaboratories. You’ll find safety precautions in yourOwner’s Manual. Read them carefully.• Installation of this cooktop must conform withlocal codes or, in the absence of local codes, withthe National Fuel Gas Code, ANSI Z223.1/NFPA54–Latest Edition.• Be sure your cooktop is installed properly by aqualified installer or service technician.• To eliminate reaching over surface burners,cabinet storage above burner should be avoided.• Do not install the unit near an outside door orwhere a draft may affect its use.IN THE COMMONWEALTH OF MASSACHUSETTS:• This product must be installed by a licensedplumber or gas fitter.• When using ball-type gas shut-off valves,they shall be the T-handle type.• A flexible gas connector, when used, must notexceed 3 feet.Be sure the installation of this product in a mobilehome conforms with the Manufactured HomeConstruction and Safety Standard, Title 24 CFR,Part 3280. If this standard does not apply, youmust follow the standard for Manufactured HomeInstallations, ANSI A225.1 and Manufactured HomeInstallations, Sites and Communities, ANSI/NFPA501A or with local codes. You can get a copy ofthe Federal Standard by Writing:Office of Mobile Home StandardsHUD Building451 7th Street, S.W.Washington, D.C. 24010Safety Information2