GE Monogram ZV1050 Owner's Manual

Also see for Monogram ZV1050: Use and care guide Installation instructions Owner's manual Owner's manual Owner's manual

Contents

7Care and CleaningStainless Steel HoodFor yoursafetyPour votresecuritéBefore servicing or cleaning unit, switch poweroff at service panel and lock the servicedisconnecting means to prevent power frombeing switched on accidentally. When theservice disconnecting means cannot be locked,securely fasten a prominent warning device,such as a tag, to the service panel.Avant de réparer ou de nettoyer votre appareil,débranchez le courant au niveau du panneaude service et verrouillez les mécanismes dedébranchement de service pour éviter toutbranchement accidentel au courant. Si vousne pouvez pas verrouiller les mécanismesde débranchement de service, attachezsoigneusement un avertissement bien visible,comme une étiquette, au panneau de service.Light bulbs To change the light bulbs:1. Remove the trim ring by turning itcounterclockwise.2. Grasp the bulb on the edges andpull it straight out.3. Replace with the same size bulb.These 12 volt, 20 watt halogen bulbsare available at specialty lighting stores.Ask for GE bulb or equivalent:Q20MR16/C/CG40–BAB.MetalgreasefilterCleanfilterlightClean the grease filter after 30 hours of “on” time.A red signal light will alert you when 30 hourshas passed.Remove the grease filters and wash themeither by hand or in the dishwasher usingnon-abrasive soap.To clean, swish the filters in hot soapy wateror wash them in the dishwasher. Do not useabrasive cleansers.Replace the filters and make sure that they arecorrectly seated in the filter channels. Adjust asnecessary until the red signal light stops blinking.HoodsurfacesDo not use a steel wool pad; it will scratchthe surface.To clean the stainless steel surface, use warmsudsy water, a stainless steel cleaner such as KleenKing®, or an all-purpose liquid or spray cleaner.Always scrub in the direction of the grain. Rinsethoroughly with a sponge or cloth and cleanwater. Dry with a soft, clean cloth.After cleaning, use a stainless steel polish, such asStainless Steel Magic®, Revere Copper andStainless Steel Cleaner® or Wenol All PurposeMetal Polish®. Follow the product instructionsfor cleaning the stainless steel surface.NOTE: To remove filters,push them back anddown using the knob.FrontFor proper operation, makesure the filters are securelyseated into the channels.On some models, the lights arelocated on the front and back,on the underside of the hood.On some models, the lightsare located on the sides,on the underside of the hood.