GE Monogram ZV30H Owner's Manual

Also see for Monogram ZV30H: Owner's manual Installation instructions Installation instructions

Contents

Controls and FeaturesStainless Steel HoodControls ..3..ON/OFF Button : Turns both fan and lightson to default (or user programmed) settings.Default settings are FAN medium, LIGHT level2. See below for details on how to programthe control to your preferred settings. If thehood is in active mode (fan on and/or lumpson), when the user presses the ON/OFFbutton, all functions will be turned off.Fan -: Pressing the fan decrease (-) buttonwill step the blower down to the next lowerblower speed, looping in this order: BOOSTHIGH _ MEDIUM _ LOW _ OFF _ BOOST...Fan +: Pressing the fun increase (+)buttonwill step the blower up to the next higherblower speed, looping in this order: LOWMEDIUM_ HIGH _ BOOST_ OFF _ LOW...Light -: Pressing the light decrease (-) buttonwill step the lamp intensity down to the nextlower intensity, looping in this order: Level 4Level 3 _ Level 2 _ Level $ _ OFF_ Level 4..."Light -"Light IntensityDecrease"Light+"Light IntensityIncrease"Fan -"SpeedDecrease"Fan +"SpeedIncreaseON/OFFButtonS. Light +: Pressing the light increase (+)buttonwill step the lamp intensity up to the next higherintensity, looping in this order: Level 1 _ Level 2Level 3 _ Level 4 _ OFF _ Level 1...ProgrammingsettingsYou have the option of changing the factorydefault (or previously programmed) settings for theON/OFF button.. With all functions off, press and hold the ON/OFF button for :3 seconds. The fan speed willbe on medium and the light intensity will be onLevel 2 (or previously programmed settings).The hood lamps will blink :3 times. Release thebutton.. The control is now in programming mode.You can set the fan and light settings to yourpreferred setting by pressing the Fan +, Fan -,Light +, and Light - buttons.NOTE:You do not have the option of settingthe fan or lights to OFF.3. When the desired fan and light settings havebeen selected, press the ON/OFF button tostore these settings. You have :30 seconds tocomplete this task.NOTE:If the control is in programming mode and:30seconds have passed with no button activitydetected, the control will revert to the last saved fanand light setting (default or programmed).Power interruptions will cause the controls to revertto the factory settings.Heat sensor To protect the electronics, this hood is equippedwith an Auto On feature that will automaticallyturn on the blower or increase the speed ifexcessive heat is detected above the cookingsurface.When the Auto On feature is activated, you mayincrease the fan speed but you cannot lower the fanspeed or turn off the blower. The hood will remain inAuto On mode until temperatures have dropped toacceptable levels.The fan speed will change to theoriginal user setting when Auto On is deactivated.The Auto On feature will always have priority overthe fan speed set by the user.4