GE Monogram ZV750 Installation Instructions Manual

Also see for Monogram ZV750: Owner's manual Owner's manual Owner's manual Owner's manual Owner's manual

MaskingtapeGlovesUtility Knife6POWER SUPPLYIMPORTANT – (Please read carefully)WARNING:FOR PERSONAL SAFETY, THIS APPLIANCE MUSTBE PROPERLY GROUNDED.Remove house fuse or open circuit breaker beforebeginning installation.Do not use an extension cord or adapter plug withthis appliance. Follow National Electrical Code orprevailing local codes and ordinances.Electrical supplyThis vent hood must be supplied with 120V, 60Hz,and connected to an individual, properly groundedbranch circuit, and protected by a 15- or 20-ampcircuit breaker or time-delay fuse.• Wiring must be 2-wire with ground.• If the electrical supply does not meet the aboverequirements, call a licensed electrician beforeproceeding.• Route house wiring as close to the installationlocation as possible. Wiring can enter from theceiling or rear wall. Route additional length fromthe ceiling or wall to reach the junction box.• Connect the wiring to the house wiring inaccordance with local codes.Grounding instructionsThe grounding conductor must be connected toa ground metal, permanent wiring system, or anequipment-grounding terminal or lead on the hood.WARNING: The improper connectionof the equipment-grounding conductor can resultin a risk of electric shock. Check with a qualifiedelectrician or service representative if you are indoubt whether the appliance is properly grounded.TOOLS AND MATERIALS REQUIRED(NOT SUPPLIED)PliersWire cutter/stripperMetal snipsSpirit levelAluminizedduct tapeSafety glasses120V 60Hz. 15- or 20-Amp,2-wire with ground, properlygrounded branch circuitStepladderSaber saw or Key Hole sawPhillips screwdriverStrain relief forjunction box6ļ round metalduct, length tosuit installationHammerElectric drill with 1/8ļ bits,#2 Phillips and flat headFlashlightUL-listed wire nutsPencil and tape measureInstallation Preparation