Specification Created 6/09 130680ZV850SPSSGE Monogram® 36" Stainless Steel Island Hood605Dia150*Heightto Ceiling8-1/4"35-3/8"27-1/2"This vent hood may be vented to the outdoors or it can beinstalled for recirculating operation. All necessary partsfor recirculating operation are supplied with the hood.No kits required.A decorative duct cover is provided to cover the ductfrom the top of the hood to a 7'11" to 8'7" ceiling for ventmode (8'11" for recirculating mode).Accessories:An optional stainless steel duct cover is available for 8'7"to 10'1" ceiling heights for vent mode (10'4" for recirculatingmode). Order ZX8510SPSS optional duct cover at the sametime as the vent hood and have on site before installation.For answers to your Monogram,® GE Profile™or GE® appliance questions, visit our websiteat geappliances.com or call GE Answer Center®service, 800.626.2000.Dimensions and Installation Information (in inches)Listed byUnderwritersLaboratoriesDimensions and Clearances:The vent hood should be installed 24" min. and 30" max.above the cooking surface, dependent on the ceiling height.The cooking surface should be at least 36" above the floor.Installation will be easier if the vent hood is installed beforethe range or cooktop/countertop is installed.This hood can be installed over a Monogram electric or gascooktop. It cannot be installed over a Monogram professionalrangetop or range.Installation Information: Before installing, consultinstallation instructions packed with product or availableon monogram.com for current dimensional data.Note: Installation height should be measured from thecooking surface to the lower edge of the hood.605Dia15124" to 30"36" Min.The exact installation height is determined by the ceiling heightand duct cover trim strips provided with the hood. For optimumperformance, the hood must be installed 24" min. and 30" max.above the cooking surface.