GE NX-591E Installation And Startup Manual

Also see for NetworX Series: Installation and startup Installation and start-up manual Installation manual User manual Installation and startup

Contents

NX-591E8X. PROGRAMMING THE MODULEA. USING THE LED KEYPADACTION RESULT1. Entering the Program Mode& Á _ Enters the Program Mode.Stay, Chime, Exit, Bypass & Cancel LEDS willflash.& Go To Program CodeFactory Default is`^XZIf the "Go To Program Code" is valid, the"Service" LED will flash and the 5 function LEDswill illuminate steady. You are now in the ProgramMode and ready to select the module to program.2. Selecting the Module to Program:& ^ ] # The address of this cellemetry module is 76.The Armed LED will illuminate while it is waitingfor a programming location to be entered.3. Factory Defaulting the Module& ` X W # The keypad will beep 3 times indicating that theloading is in progress. Remember you will eraseany values you may have entered previously.4. Programming a Location:Once the number of the module to be programmed has been entered, the "Armed" LED willilluminate while it is waiting for a programming location to be entered." If an attempt is made to program an invalid entry for a particularsegment, the keypad sounder will emit a triple error beep (beep, beep,beep), and remain in that segment awaiting a valid entry.To Enter a Location:& [location] # The Armed LED will flash. If the location is valid,the "Armed" LED will extinguish, the "Ready" LEDwill illuminate, and the zone LED’s will show thedata for the first segment of this location.