TMSpecification Created 1/03JP969BH/CH/SH/WH – GE Profile™ 36" Built-In CleanDesign CooktopCabinet Installation Dimensions (in inches) KW Rating240V 8.6208V 6.5Breaker Size240V 36 Amps†208V 31 Amps†Flush Mount Installation KitAccommodates both 30" and 36" installations. Not for use with stainless steel models.JXFLMBB (Black—use with black glass cooktops with a white, bisque or black pattern)Installation Information:Before installing, consult installation instructions packed with product for currentdimensional data.†Note: Check local codes for required breaker size.Built-In CleanDesign CooktopsRequires a 5" free area between the bottom of the cooktop to any combustible material, i.e.,shelving. Free area not required when installing wall oven underneath cooktop. Refer to installationinstructions. Requires an 18" minimum from cooktop to adjacent overhead cabinets. Unitsare furnished with a 48" flexible armored cable.36" Ribbon cooktops are approved for use over GE 30" Single Wall Ovens and warming drawers.Refer to cooktop and wall oven installation instructions packed with product for currentdimensional data.Notes: If installing with a GE Profile Telescopic Downdraft System, consult both cooktopand downdraft installation instructions packed with product before installing. Cooktopgas/electric supply may need to be re-routed to install downdraft.The countertop must be at least 26" deep with a flat surface area of 23-1/2" or more, front toback. In addition, other clearances to the front edge of the countertop must be considered.Note: Consult cabinet and countertop manufacturer’s specs for flush mount installationprior to install.Electrical junctionbox 16" MIN.below countertop30" MIN. tounprotectedcabinetCut should not interferewith cabinet structureat front1-3/4" MIN.clearance toside wallfrom cut-out1-1/2" MIN.clearance toside wallfrom cut-out18" MIN.to cabinet1-3/4" torear wall13" MAX.depth3-1/4"*Cooktop2-1/2"Required33-7/8"19-1/8"36"** 20-3/8"****Depth of unit at conduit connection location (rear) is 6-1/4".**Width and Depth of stainless model is 36-1/8" and 21".RListed byUnderwritersLaboratoriesFor answers to your Monogram,® GE Profile™ orGE appliance questions, visit our website atGEAppliances.com or callGE Answer Center® service, 800.626.2000.