Installation InstructionsTo use toggle bolts:Spacing for Toggles More_l_,--_ii_,_ThanWallThicknessMounting iToggleWingsPlate_ !Wall BoltEnd[3_ Place the mounting plate against the wall and insertthe toggle wings into the holes in the wall to mountthe plate.NOTE: Before tightening toggle bolts and wood screw,make sure the tabs on the mounting plate touchthe bottom of the cabinet when pushed flush againstthe wall and that the plate is properly centered underthe cabinet.CA UTIO N: Becarefultoavoidpinchingfingers between the back of the mountingplate and the wall.[_ Tighten all bolts. Pull the plate away from the wallto help tighten the bolts.IB31 USE TOP CABINET TEMPLATEFOR PREPARATION OF TOPCABINETYou need to drill holes for the top support screws andu hole large enough for the power cord to fit through.• Read the instructions on the TOP CABINETTEMPLATE.• Tape it underneath the top cabinet.• Drill the holes, following the instructions on theTOP CABINET TEMPLATE.A ,-,^, ,-,-,,-,ml_._/_Id/l_J I_1: Wear safety goggles whendrilling holes in the cabinet bottom.[-_ ADAPTING BLOWER FOROUTSIDE BACK EXHAUST[_ Remove the three screws that hold the blowerplate to the oven. Slide blower plate from underits retaining flange. Remove and save the screwthat holds blower motor to oven.Retaining _ j _Flange_ ___- BlowerPlateBlowerMotor........" JScrew[_ Carefully pull out the blower unit. The wireswill extend far enough to allow you to adjustthe blower unit.BEFORE: Fan BladeOpenings FacingEnd[3_ Rotate blower unit counterclockwise 180°.Before RotationOvenAfter RotationOven[_ Gently remove the wires from the grooves.Reroute the wires through grooves on other sideof the blower unit.BeforeRerouting After ReroutingWires RoutedThroughRightSide Wires RoutedThroughLeft Side16