10Installation PreparationPreparation WITH an Accessory Storage DrawerNOTE: MODEL ZSC1201 CAN ONLY BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER IF INSTALLED ABOVE 36-3/4s.MODEL ZSC1202 CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE INSTALLATION PREPARATION WITHOUTAN ACCESSORY STORAGE DRAWER FOR THIS MODEL.Installation over a GE/MonogramWarming Drawer:NOTE: Additional clearances between the cutoutsmay be required. Check to be sure the ovensupports above the Warming Drawer locationdo not obstruct the required interior depthand height. See Warming Drawer installationinstructions for details.30s 23-1/2s25-1/4sMin.21s 2s Min.(3s Recommended)Per WarmingDrawerRequirementConstruct SolidBottom Min. 3/8sPlywood Supportedby 2 x 4 or 2 x 2Runners all FourSidesPREPARE THE OPENING (cont.)The Advantium 120V can be installed incombination with other GE/Monogram appliances.Always follow each product’s InstallationInstructions to complete the installation.Single Advantium 120V Installation:Order a 30s wide single oven cabinet or cutthe opening in a wall to the dimensions shown.$OORZs case trim overlap on the sides,1-1/16s overlap on the top and 7/8s overlapon the bottom of the opening for all models.2YHQRYHUODSVZLOOFRQFHDOFXWHGJHVRQDOOVLGHVof the opening.When installed over a single oven or a warmingdrawer, allow at least 2s between the twoopenings. This separation will provide clearancefor bottom overlap of the Advantium 120V and theother appliance overlaps.Construct a solid oven floor of 3/8s min. thick plywoodsupported by 2 x 4 or 2 x 2 runners on all sides.7KHVXSSRUWPXVWEHOHYHODQGULJLGO\PRXQWHGflush with the bottom edge of the cutout.30s 23-1/2s25-1/4sMin.21sConstruct BaseMin. 3/8s PlywoodSupported by 2 x4 or 2 x 2 Runnersall Four SidesPREPARE THE OPENING (cont.)36-3/4sMin.**Required forMonogram models*Required forMonogram models36-3/4sMin.*