Before you call for service.., jTroubleshooting TipsSave time and money! Review the chart below first andyou may not need to coil for service.Possible Cause What To DoDryer won't Control panel is asleep • This is normal. PressPOWER.operate Dryer is unplugged • Make sure cord is plugged securelg into a working outlet.Controls are not set properly . Make sure the cgcle was set correctlg, close the lid andpress START.Fuse is blown/circuit breaker . Check house circuit breakers/fuses. Replacefuses or resetis tripped breaker. NOTE:Electricdrgers use two fuses or breakers.Electronics need to be reset • Unplug drger,wait 2 minutes, plug back in and press POWER.STARTwas not pressed after • PressSTART.a cycle was setDoor was opened during the . Close the door and reset cgcle, to the beginning if necessarg.dry cycle PressSTART.Dryer is too cold . If the drger has been exposed to temperatures below freezingfor an extended period of time, allow it to warm up beforepressing POWER.Otherwise, the displag will not come on.CLg in display Exhaust duct blocked . Checkall of gour exhaust ducting including transition ducts,window wall caps and around turns. Contact a qualified serviceprovider if necessarg.Normal Operating SoundsThe following are normal sounds you may hear:DescriptionThumping noise when ifthe drger has not been used for an extended period of time, gou mag hear a thumping noisedrum rotates from temporarg flat spots on the drum support rollers. The noise will go awag after use.34