49-2000915 Rev. 0InstallationInstructionsIf you have questions, call GE Appliances at 800.GE.CARES (800.432.2737)or visit our website at: GEAppliances.comBEFORE YOU BEGINRead these instructions completely and carefully.Ŷ IMPORTANT – Save these instructionsfor local inspector’s use.Ŷ IMPORTANT – Observe all governingcodes and ordinances.Ŷ Note to Installer – Be sure to leave theseinstructions with the Consumer.Ŷ Note to Consumer – Keep these instructions forfuture reference.Ŷ Skill level – Installation of this vent hood requiresbasic mechanical and electrical skills.Ŷ Completion time – Approximately 4 to 6 hoursŶ Proper installation is the responsibility of theinstaller.Ŷ Product failure due to improper installation is notcovered under the Limited Warranty.PRODUCT DIMENSIONSINSTALLATION CLEARANCESThese vent hoods aredesigned to be installedonto a wall with no abovecabinets.• Install these hoodsbetween the required24” minimum and36” recommendedmaximum above thecooking surface.The vent hood must beinstalled between therequired 24” minimumand 36” recommended maximum above the cookingsurface. The hood installation height above thecooking surface depends upon ceiling height andduct cover limitations. The telescopic duct coverconceals the ductwork running from the top of thehood to the ceiling.NOTE: Installation height should be measured fromthe cooking surface to the lowest part of the hood.This hood must be installed onto a wall. It can bevented to the outdoors, or it can be installed forrecirculating operation. Recirculating Kit includedwith hood.Island Chimney Vent HoodINSTALLATION INSTRUCTIONSCAUTION Due to the weight and size ofthese vent hoods and to reduce the risk of personalinjury or damage to the product, TWO PEOPLEARE REQUIRED FOR PROPER INSTALLATION.FOR YOUR SAFETY:WARNING Before beginning the installation,switch power off at service panel and lock theservice disconnecting means to prevent power frombeing switched on accidentally. When the servicedisconnecting means cannot be locked, securelyfasten a prominent warning device, such as a tag, tothe service panel.* For supplied duct cover ceiling height for vented installation andrecirculating installation, refer to the table on page 12.´*Height toceiling´ ´´´*Height to CeilingVented RecirculatingMin ´ ´Max ´ ´24” Required Min.36” Recommended Max.36” Typical