GE PVM1790 Installation Instructions Manual

Also see for Profile CVM1790: Owner's manual Installation instructions Installation instructions Owner's manual Installation instructions

Contents

GE PVM1790 Installation Instructions Manual Manual pdf 19 page image

Installation Instructions[ RECIRCULATING (Non-Vented Ductless)INSTALLATION OVERVIEWC1. Attach Mounting Plate to WallC2. Prepare Top CabinetC3. Adjust BlowerC4. Mount the OvenC5. Install Charcoal Filter (not supplied)ATTACH THE MOUNTING PLATETO TH E WALLAttach the plate to the wall using toggle bolts. At leastone wood screw must be used to attach the plate toa wall stud.[_ Remove the toggle wings from the bolts.[_ Insert the bolts into the mounting plate throughthe holes designated to go into drywall and reattachthe toggle wings to ¾" onto each bolt.To use toggle bolts:MountingSpacingforTogglesMoreThanWall-_..-_i_ Thicknessii ToggleWingsJVall BoltEnd[_ Place the mounting plate against the wall and insertthe toggle wings into the holes in the wall to mountthe plate.NOTE: Before tightening toggle bolts and wood screw,make sure the tabs on the mounting plate touch thebottom of the cabinet when pushed flush against thewall and that the plate is properly centered under thecabinet.CAUTI O N: Becarefultoavoidpinchingfingers between the back of the mounting plate andthe wall.[_ Tighten all bolts. Pull the plate away from the wallto help tighten the bolts.I-_-1 USETOP CABINETTEMPLATEFORPREPARATIONOF TOP CABINETYou need to drill holes for the top support screws anda hole large enough for the power cord to fit through.19• Read the instructions on the TOP CABINETTEMPLATE.• Tape it underneath the top cabinet.• Drill the holes, following the instructions on the TOPCABINET TEMPLATE.A,,-^| ,T,,-,_,J::IL,/'_U/I U I_1 : Wear safety goggles whendrilling holes in the cabinet bottom.