GE PVUS930 Owner's Manual And Installation Instructions

10READ AND SAVE THESE INSTRUCTIONS.GENERALCarefully read the folloZing important information regarding installation safety andmaintenance. Keep this information booNlet accessible for further consultations. The appliancehas been designed for use in the DUCTING version air exhaust to the outside Fig.1A - Fig.1B) orFILTERING Optional KIT0320 for 30μ 7.2 cm) model and KIT0321 for 36μ 91.4 cm) model.INSTALLATION INSTRUCTIONSWARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS,OBSERVE THE FOLLOWING:A. Installation ZorN and electrical Ziring must be done by quali¿ed person s) in accordanceZith all applicable codes and standards, including ¿re-rated construction.B. Suf¿cient air is needed for proper combustion and exhausting of gases through the Àuechimney) of fuel burning equipment to prevent bacN drafting. FolloZ the heating equipmentmanufacturer’s guideline and safety standards such as those published by the National FireProtection Association NFPA), and the American Society for Heating, Refrigeration and AirConditioning Engineers ASHRAE), and the local code authorities.C. When cutting or drilling into Zall or ceiling, do not damage electrical Ziring and other hiddenutilities.D. Ducted fans must alZays be vented to the outdoors.E. This unit must be grounded.WARNING - TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK.Attention!- Before carrying out assembly operations, open the pacNaging, taNe the hood and place iton a comfortable surface.- Remove the anti-grease ¿lter/s Fig.1C).A. If hood installation is used Zith the air outlet Fig.1B or Fig.4B, the Zires set-up in therelevant Ziring harness must be released by pulling the lever outZards, as indicated in¿gure 2, phase 1-2.B. Disconnect the 6-Zay quicN coupling of the motor located inside of the hood, as shoZ in¿gure 2. - phase 3.C. The Zires positioned inside of the hood are fasted Zith a cable tie. Cut the cable tie asshoZn in ¿gure 2 - phase 4.Once transformation operations have been completed, reassemble the components folloZingthe steps in reverse Fig.2).In this Zay it Zill be easier to manoeuvre the unit.- If the appliance is to be mounted in DUCTING version, prepare the air evacuation hole.- It is recommended to use an air evacuation pipe Zith the same diameter as the air outletÀange. The use of a reduction could decrease product performance and increase noise.Attention! This product utilizes the air evacuation hole available in 2 different positions,Zhich can be used according to your requirements;1 – In the upper part of the hood Fig.1A.2 – In the rear part of the hood Fig.1B.- The air evacuation Àange is supplied Zith the rectangular shape X and circular shape YFig.1).