GE Professional Outdoor Grills and Cooktop Installation Instructions Manual

Also see for Monogram ZGG300LB: Installation instructions

Contents

GE Professional Outdoor Grills and Cooktop Installation Instructions Manual Manual pdf 17 page image

Installation Instructions17NATURAL GAS GRILL CONNECTIONS• The gas supply line must be sized toaccommodate the outdoor grill and, if present, anoutdoor cooktop connected to the same gassupply.• The grill or cooktop and its individual shut-offvalve must be disconnected from the gas supplyduring any pressure testing of the system at testpressures in excess of 1/2 PSIG.1/2" Male to 3/4"Female ElbowBuilt-in models shown.Make connection for models installed on carts in the samemanner. The entry for the gas line is on the back of the cart.Outdoor Cooktop: Install the cooktop using the same methodillustrated above for the outdoor grills.The installation of the outdoor grills or cooktop mustconform with local codes or, in the absence of localcodes, with the National Fuel Gas Code, ANSIZ223.1, latest edition.Operating pressure is 4" water column. Supplypressure should be 5" to 14" water column. Ifpressure is more than 14" water column, astep-down regulator is required.Check with the local gas utility or with local codesfor instructions on installing gas supply lines. Besure to check on type and size of run and how deepto bury the line. If the gas line is too small, the grillwill not function properly.• Install a manual gas shut-off valve in an easilyaccessible location.• Use threading compound on male threads only.Do not use threading compound on the male endof a flare adapter.• Make connections as shown.• Check to be sure the regulator arrow points in thedirection of gas flow, towards the grill and awayfrom the gas supply.Incoming NaturalGas Supply PipeRegulator3/4" Min. Dia.Flexible Connector Manual Shut-OffValve3/4" NPT to3/4" FlareFittingOutdoor Cooktop: Install the cooktop with aseparate tank using the same method. OrderWB21X10156 Regulator hose assembly for the20-lb. tank connection.To connect 20-lb. LP tank:• Attach the regular hose assembly to the brasselbow. Do not use threading compound.• Insert the coupler sleeve on the regulator overthe tank inlet; turn clockwise to tighten. Do notovertighten the coupler.To disconnect from the 20-lb. LP tank:• Turn tank valve to OFF.• Grasp the coupler sleeve, turn counterclockwiseand remove.LP GAS GRILL CONNECTIONS TO A GRILL OR COOKTOP (cont.)Built-in models shown.For models installed on carts, open the tank storage drawer on theright side to make the tank connection.3/8” FlareFitting20-lb. Type 1 LP TankLP Hose andRegulatorSingle Gas Cooktop or Grill Connection