GE Profile 165D4700P176 Owner's Manual

Contents

OptionsThe light above the pad will be ON to indicate which OPTION has been selected.HI TEMP RINSE Turns on the heater in all prerinse and final rinse cycles to help prevent spotting ondishware. This option may be turnedON orOFF during the wash cycle.HI TEMP WASH Energizes the heater in all prewash fill cycles. Recommended for use with heavilysoiled dishes. Option may be turnedON orOFF during the wash cycle.HEATED DRY Shuts off the drying heat options. Dishes air dry naturally and energy is saved. YouOFF can prop the door open after the light goesON below the wordCLEAN.HEATED DRY Turns the heater on for fast drying. This cycle will extend the time to your washON cycle by 30 minutes.NOTE: Cannot be selected withRINSE & HOLD cycle.LOCK When theLOCK pad is touched twice within 3 seconds, all pads become inoperative.You can lock the controls to prevent any selections from being made. Or you can lockthe controls after you have started a cycle or selected DELAY START so the cycle orDELAY START is not interrupted.Children cannot accidentally start dishwasher by touching pads with thisoption selected.To unlock the dishwasher after it has been locked, touch theLOCK pad twicewithin three seconds. The light above theLOCK pad will be off.DELAY START You can delay the start of a wash cycle for up to 8 hours. Press and hold theDELAY START pad to choose the number of hours you want to delay the startof the cycle. The machine will count down and start automatically at the correcttime.NOTE: If you forget to lock the door a reminder signal will beep until youdo so.RESET To change a cycle after washing starts, touch theSTART/RESET pad to cancelthe cycle. After water is pumped out and motor stops, you can reprogram andrestart the dishwasher.Customer ServiceTroubleshooting TipsOperating InstructionsSafety InformationStartClose the door until it locks into place and touch theSTART/RESET pad tobegin the cycle. There is a time delay between start-up and water fill so youwill not hear any wash action right away.The cycle is complete when the light isON below the wordCLEAN.32NOTE: The dishwasher remembers your last cycle so you don’t have toreprogram each time. When the dishwasher is loaded and door latch is in thelocked position, the control panel lights will beON and display the last settingsyou selected.If you don’t want to change any of the settings, simply touch theSTART/RESETpad to begin the cycle.Also, if a power failure occurs,NORMAL andHEATED DRY ON will automatically beprogrammed. Make any new selections and touch theSTART/RESET pad to beginthe cycle.9