GE Profile 23 Owner's Manual And Installation

Also see for 25: Owners and installation manual Owner's manual Owner's manual Use and care & installation guide Use and care & installation guide

Contents

ROLLERS (CONT.) DIMENSIONS AND SPECIFICATIONS(for CustomStyle™ models)25After leveling, make sure that the refrigerator door is 1/16″higher than the freezer door.To align the doors, adjust the refrigerator door.Using a 7/16″ socket wrench, turn the door adjustingscrew to the right to raise the door, to the left to lowerit. (A nylon plug, imbedded in the threads of the pin,prevents the pin from turning unless a wrench is used.)After one or two turns of the wrench, open and closethe refrigerator door and check the alignment at thetop of the doors.To remove the base grille,open the doors, removethe screw at each end ofthe base grille and thenpull the grille straight out.7/16″ Socket WrenchRaise701⁄4″ (178.4 cm)36″(91.4 cm)24″ (61 cm)24″ (61 cm)CabinetWater Electrical3/4″ (19 mm) Airspace(1/2″ [13 mm] Gap +1/4″ [6 mm] Wall Plates) 25″ (63.5 cm)CountertopInstallation InstructionsDOOR ALIGNMENTTo adjust the rollers on 23′ models:Remove the base grille by opening the doors,removing the screws at each end, and pulling itstraight out.Turn the front rolleradjusting screwsclockwise to raisethe refrigerator,counterclockwise tolower it. Use a 3/8″hex socket or wrench,or an adjustablewrench.These models also have rear adjustable rollers so youcan align the refrigerator with your kitchen cabinets.Use a long-handled 5/16″ socket wrench to turn thescrews for the rear rollers–clockwise to raise therefrigerator, counterclockwise to lower it.Replace the base grille.Roller adjusting screwsRefrigerator doorneeds to be raised.