GE Profile 42 Owner's Manual And Installation Instructions

Also see for Outdoor cooking center 48: Owner's manual Use and care guide Owner's manual Owner's manual Installation instructions

Contents

Replacing the light bulbs.Setting the controls to OFF does not remove power to the light circuit........................................................................................Refrigerator Compartment--Upper Light(appearance may vary)@ Raise the grille panel, set the masterpower switch to the 0 (off)i_osifion andallow lami)s to cool.@ To remove the light shield, press on thesides of the shield and pull down.@ Replace the bulbs Mth appliance bulbsof the same or lower wattage, . Rei)lacethe shield by engaging the bottom tabinto the slot and apI)lying light fiwwardpressure until the shield snaps in place.@ Set the master power switch h) the I (On)position and close the grille panel.t Refrigerator Compartment--Lower LightThis hght is located above the top drawer@ Raise the grille panel, set the masterpower switch to the 0 (off) I)osifion andallow lamps to cool.Remove items flxm_ the shelf above thelight shield. Remove the shelfiUse both hands to grasp each end ofthe light shield. Press in on the bottomol the shield with your thumbs whilerotating the cover up and out.O Replace the bull) with an appliancebulb of the same or lower wattage.Replace the shield by engaging thebottoln tab into the slot aim appl)h_glight fiwward pressure until the shieldsnaps in place.O Set the inaster power switch to the I (On)position and close the grille panel.Freezer Compartment@ Raise the grille panel, set the inasterpower switch to the 0 (Off) position aimallow lamps to cool.@ ]_emoxe the items fl'om the shelf justbelow the light shield. Remoxe theshelfi@ To remoxe the light shield, press downon the top of the shield and pull thetabs ()tit of the shits. Tilt the shieldfi)rward aild ()tit.Replace the bull) with an appliancebulb of the Salne or lower wattage,and reinstall the light shield. ]),el)lacethe shield by engaging the bottoln tabinto the slot and aI_plying light torwardpressure until the shield snaps in place.O Set the inaster power swimh to the I (On)position and close the grille panel.Dispenser@ Raise the grille panel, set the masterpower switch to the 0 (Off) position andallow lamps to cool.@ The bulb is located in the dispenserunder the control panel. Remove thetwo screws fl'om the light shield. Slidethe light shield toward the dispenser todisengage the tabs, then remove thelight shield. Renlove the light bulb byturIfing it counterclockwise.Replace the bulb with a bulb of thesame size and wattage. Replace thelight shield by sliding the tabs intothe slots in the fl'ont of the dispenser.Replace the two screws.@ Set the master power switch to the I (on)position and close the grille panel.14