GE Profile 465 Owner's Manual

Also see for Profile 405: Owner's manual Owner's manual Owner's manual

Contents

WARNING!n Do not overload the Drying Center. It may be damaged if more than 20 lbs. are applied.n Always store the Drying Center in a safe position so that it does not hit anyone.n Do not allow children to play with the Drying Center.The pole on the Drying Center can be set at different heights. Line up the tabs onthe pole with the notch on the brackets (this will occur when the pole is parallel tothe control panel) and raise or lower the pole, resting the tab on the bracket at theheight you want.The Drying Center can be mounted on either side of the dryer.To remove and transfer the Drying Center to the opposite side:Remove the pole by raising it up. Make sure to line up the tabs on the pole with thenotches on the bracket.Remove the four screws that secure the bracket to the dryer. Three of the screws willbe required to mount the bracket on the other side. The fourth screw at the top ofthe side panel flange (shown in circled illustration) needs to be put back into itsoriginal location.On the other side of the dryer remove the screw at the top of the side panel flange(shown in circled illustration).Turn the bracket upside down and attach it with the screw you just removed and withthe three screws that were removed from the other side.WARNING!Make sure you use only these screws. Never use any long screws (must be less than 3/8″) orpointed screws.Insert the pole into the mounting bracket.543219Customer ServiceTroubleshooting TipsOperating InstructionsSafety InstructionsDrying Rack–on some modelsA handy drying rack may be used for dryingarticles such as stuffed toys, pillows orwashable sweaters.Hook the rack over the lint filter so the rackextends into the dryer drum.NOTE:n The drying rack must be used with theTIMED CYCLE.n Do not use this drying rack when there areother clothes in the dryer.About the drying center (on some models).