GE Profile DPVH890 Owner's Manual & Installation Instructions

Also see for Profile DPVH890: Owner's manual and installation instructions Owner's Manual & Installation Instructions Owner's manual and installation instructions Owner's Manual & Installation Instructions

BEFORE YOU BEGINRead these instructions completely and carefully.• IMPORTANT – Save these instructions forlocal electrical inspector’s use.• IMPORTANT – Observe all governing codesand ordinances.• Install the clothes dryer according to themanufacturer’s instructions and local codes.• Note to Installer – Be sure to leave theseinstructions with the Consumer.• Note to Consumer – Keep these instructions forfuture reference.• Clothes dryer installation must be performedby a qualified installer.• This dryer must be exhausted to the outdoors.• Before the old dryer is removed from service ordiscarded, remove the dryer door.• Service information and the wiring diagram arelocated in the control console.• Do not allow children on or in the appliance.Close supervision of children is necessary whenthe appliance is used near children.• Proper installation is the responsibilityof the installer.• Product failure due to improper installationis not covered under the Warranty.• To reduce the risk of severe injury or death,follow all installation instructions.Installation DryerInstructions DPVH890 and UPVH89013Questions? Call 800.GE.CARES (800.432.2737) or visit our Web site at: ge.comIn Canada, call 1.800.561.3344 or visit geappliances.caFOR YOUR SAFETY:WARNING – Risk of Fire• Use only rigid metal or flexible metal 4-inchdiameter ductwork for exhausting to theoutdoors. Never use plastic or other combustibleeasy-to-puncture ductwork.• Do not install a clothes dryer with flexible plasticventing materials. If flexible metal (foil type) ductis installed, it must be of a specific type identifiedby the appliance manufacturer as suitable for usewith clothes dryers. Flexible venting materials areknown to collapse, be easily crushed, and traplint. These conditions will obstruct clothes dryerairflow and increase the risk of fire.• This appliance must be properly grounded andinstalled as described in these instructions.• Do not install or store appliance in an area whereit will be exposed to water and/or weather.• The National Fuel Gas Code restricts installationsof gas appliances in garages. They must be 18inches off the ground and protected by a barrierfrom vehicles.• Install the dryer where the temperature is above50°F for satisfactory operation of the dryercontrol system.FOR GAS MODELS ONLY:NOTE: Installation and service of this dryer mustbe performed by a qualified installer, serviceagency or the gas supplier.In the Commonwealth of Massachusetts:• This product must be installed by a licensedplumber or gas fitter.• When using ball-type gas shut-off valves, theyshall be T-handle-type.• A flexible gas connector, when used, must notexceed 3 feet.