GE Profile JGB905 Owner's Manual & Installation Instructions

Also see for Appliances Profile JGB900: Owner's manual and installation instructions Owner's Manual & Installation Instructions Owner's Manual & Installation Instructions Owner's Manual & Installation Instructions Owner's manual

To remove the oven bottom:A. Remove the knurled screws holding down rear of theoven bottom.B. Grasp the oven bottom at finger slots on each side.C. Lift the rear of the oven bottom enough to clear thelip of the range frame, push it back, and then pull itup and out.48Installation InstructionsADJUST BROIL AND OVENBURNER AIR ADJUSTMENTSHUTTERS IF NECESSARY7Air adjustment shutters for the top and bottom burnersregulate the flow of air to the flames.The air adjustment shutter for the top (broil) burner isin the center of the rear wall of the oven.The shutter for the bottom (oven) burner is near theback wall behind the warming drawer. Remove thedrawer. See the Care and cleaning of the range section.To adjust the flow of air to either burner, loosen thePhillips head screw and rotate the shutter toward openor closed position as needed.The flames for the top (broil) burner should be steadywith approximately 1″ blue cones and should notextend out over the edges of the burner baffle.To determine if the bottom burner flames are burningproperly, remove the oven bottom. Flames should haveapproximately 1″ blue cones and, if range is suppliedwith natural gas, should burn with no yellow tipping.(With most LP gas, small yellow tips at the end of outercones are normal.) Flames should not lift off burnerports. If lifting is observed, gradually reduce air shutteropening until flames are stabilized.ADJUST BROIL AND OVENBURNER AIR ADJUSTMENTSHUTTERS IF NECESSARY (CONT.)7Airadjustment shutterLoosenAir adjustmentshutterLoosenOven bottomLEVELING THE RANGE8A. Install the oven shelves in the oven and position therange where it will be installed.B. Check for levelness by placing a spirit level or a cup,partially filled with water, on one of the oven shelves.If using a spirit level, take two readings—with thelevel placed diagonally first in one direction andthen the other.C. Remove the drawer. See the Care and cleaning of therange section. The front leveling legs can be adjustedfrom the bottom and the rear legs can be adjustedfrom the top or the bottom.D. Use an open-end or adjustable wrench to adjust theleveling legs until the range is level.E. After the range is level, slide the range away from thewall so that the Anti-Tip device can be installed.LeglevelerLowerrangeRaiserange(on some models)Raiserange Lowerrange(on some models)