GE Profile PDW8200 Series Owner's Manual

Also see for Profile PDW8200 Series: Owner's manual Installation instructions Owner's manual Installation instructions Owner's manual

Contents

11Consumer SupportTroubleshooting TipsOperating InstructionsSafety InstructionsBefore you call for service… GEAppliances.comProblem Possible Causes What To DoControl panel lights go off Time too long between • Each pad must be touched within 30 seconds of the others.when you’re setting controls touching of selected pads To relight, touch any pad again, or unlock and relatch door.Noise Some of the sounds you’ll • Detergent cup opening.hear are normal • The motor stopping during the drying period.• Water draining out of the tub immediately after youtouch START/RESET pad.Utensils are not secure in the • Make sure everything is secured in dishwasher.rack or something small hasdropped into the rackMotor hums • Dishwasher has not been used on a regular basis. If youdo not use your dishwasher often, set it to fill and pumpout once every week. This will help keep the seal moist.Detergent left in Dishes are blocking the • Reposition the dishes.dispenser cups detergent cupsWater standing in This is normal • A small amount of clean water around the outlet on thethe bottom of the tub tub bottom at the back of the tub keeps the water seallubricated.Water won’t pump Drain is clogged • If you have an air gap, clean it.out of the tub • Check to see if your kitchen sink is draining well. If not,you may need a plumber.• If the dishwasher drains into a disposer, run disposer clear.Suds Correct detergent wasn’t used • Use only automatic dishwasher detergents to avoid sudsing.Cascade®, Cascade Complete® and Electrasol® dishwasherdetergents have been approved for use in all GE dishwashers.• To remove suds from the tub, open the dishwasher andlet suds dissipate. Add 1 gallon of cold water to the tub.Close the door until it locks into place. Pump out water bypressing START/RESET, then after waiting 10 seconds pressSTART/RESET again. Repeat if necessary.Rinse agent was spilled • Always wipe up rinse agent spills immediately.Stained dishwasher parts Detergent with • Some detergents contain colorant (pigment or dyes) thatcolorant was used will discolor the tub interior with extended use. Check thedetergent cup for signs of any discoloration. If cup isdiscolored, change to detergent without any colorant. Cascade®,Cascade Complete® and Electrasol® Dishwashing Detergentshave been approved for use in all GE dishwashers.Some tomato-based • Use of the RINSE ONLY cycle after adding the dish to the loadfoods can stain can decrease the level of staining.Dishes and flatware Low inlet water temperature • Make sure inlet water temperature is correct (see page 6).not clean Water pressure is temporarily low • Turn on a faucet. Is water coming out more slowly than usual?If so, wait until pressure is normal before using your dishwasher.Air gap is clogged • Clean the air gap.Improper rack loading • Make sure large dishware does not block the detergentdispenser or the wash arms.Troubleshooting TipsSave time and money! Review the charts on the following pages,or visit GEAppliances.com. You may not need to call for service.