Dimensions and Installation InformationFor answers to your Monogram,® GE Profile™ orGE® appliance questions, visit our website atge.com or call GE Answer Center ® service,800.626.2000.Listed byUnderwritersLaboratoriesPP989DNGE Profile™ 30" Downdraft Electric CooktopSpecification Created 7/08220977Wall Installation: Wall installationsrequire 25” countertop depth. Whencabinet is flush against the wall, thefan housing can be rotated to thehorizontal position for direct ventingthrough rear wall. Make a countertop cutout in the rangecabinet according to unit dimensions and installation type.Duct hole is positioned in back of cabinet for through-the-wall ducting. Requires special offset adapter JXRW89.Peninsula or Island Installation: For peninsula/islands aminimum 26” countertop depth is suggested. Blower shouldbe in vertical position. Island or peninsula cabinets mayrequire adjustment in cutout depth and/or location withinthe width dimensions. Duct hole is positioned in bottom ofcabinet for island or peninsula installation.Slab Installation: For peninsula or island installation andrear wall ducting, 6” PVC duct or locally approved pipingshould be used if installing under a poured concrete slab.Receptacle Location: Install an approved junction boxwithin shaded area shown in diagram. Junction box mustbe at least 10-1/2" below top of cabinet.Installation Information: Before installing, consult installationinstructions, packed with product, for current dimensionaldata. Note: Electrical cable is not supplied with unit.These cooktops are approved for indoor use only.KW Rating240V 9.1208V 6.9251-7/8"MIN. Required*20-5/8Cut-out Dimensions (in inches)28-7/8*U.L. Requirement.Note: A 6" minimum spacing to adjacent side wall is required209410-1/216CLCabinet Dimensions (in inches)*Note: A 6" minimum spacing to adjacent side wall is requiredDimension and installation information are shown in inches.227⁄16ʺ(229⁄16ʺ SS)201⁄ 2ʺ22ʺ297⁄ 8ʺ(30ʺ SS)23⁄16ʺ(21⁄ 4ʺ SS)283 ⁄4ʺ