GE Profile PT925 Technical Service Manual

Also see for Appliances PT925: Owner's manual Installation instructions Owner's manual Owner's manual Owner's manual

– 42 –Door Hinge ReceiversTo remove the door hinge receivers:Remove the side access panels. (See1. Side AccessPanels.)Carefully lift the insulation from the outside of2.the oven.Remove the two T20 Torx screws that hold each3.hinge receiver to the oven frame.4. Push the hinge receiver through the opening inthe oven frame and remove from the rear.Note: Upon reassembly, ensure the displacedinsulation around the oven and components isreturned to its original position.Meat Probe and OutletThe meat probe outlet is located on the top of theoven cavity, near the front. The meat probe outlet isconnected to the electronic oven control. The meatprobe has a resistance value of 30K-50K Ω at roomtemperature.To remove the meat probe outlet:Open the lower oven door.1.Remove the two 1/4-in. hex-head screws that2.attach the meat probe outlet to the top of theoven cavity.3. Pull the outlet and wiring down from the ovenwall.Note: When replacing the meat probe outlet, cutthe probe wires and splice the new probe usingapproved heat-resistant connectors.Cut Here Cut HereOven Light AssemblyThe oven has two light assemblies in each ovencavity. The light assemblies are located on the toprear of the oven. The lights come on when the dooris opened or when the oven is in a cooking cycle.The oven lights do not come on during self-cleaningor if the Sabbath Feature is set.Each light assembly consists of a removable lightcover, a light bulb socket, and a light bulb.To remove an oven light assembly:Remove the main rear access panel. (See1. RearAccess Panels.)Remove the three 1/4-in. hex-head screws that2.attach the panel securing the lighting assemblywires to the rear of the oven.(Continued Next Page)