44If Something Goes WrongBefore You Call For ServiceOven will notstart“PLEASE INSERTPROBE“ appearson display“SENSOR ERROR”appears on displayFloor of the oven iswarm, even whenthe oven has notbeen used“BAD PROBE”appears on display“LOCKED” appearson displayFood amount toolarge for SensorReheatWhen using a Sensor • Do not open door until steam isfeature, the door was sensed and time is shown countingopened before steam down on display.could be detected.Steam was not detected • Use Time Cook to heat for more time.in maximum amount oftime.Problem Possible Cause What to DoA fuse in your home • Replace fuse or reset circuit breaker.may be blown or thecircuit breaker tripped.Power surge. • Unplug the microwave oven, then plugit back in.Plug not fully inserted • Make sure the 3-prong plug on theinto wall outlet. oven is fully inserted into wall outlet.Probe has been • Insert the probe properly into the wallforgotten or not receptacle.inserted properly.The cooktop light is • This is normal.located below the ovenfloor. When the lightis on, the heat itproduces may make theoven floor get warm.The probe has not been • Insert the probe properly into the wallcompletely inserted receptacle.into the wall receptacle.The probe is defective. • Replace the probe.The control has been • Press and hold CLEAR/OFF forlocked. about 3 seconds to unlock the control.Sensor Reheat is for • Use Time Cook for large amountssingle servings of of food.recommended foods.