GE RAK315D Installation Instructions Manual

1IMPORTANT NOTES• This unit must be connected to a grounded circuit.• The electrical rating marked on the installed Zonelineand power supply kit must be the same as the supplybranch circuit.• Aluminum building wiring may present specialproblems—consult a qualified electrician.• All wiring, including installation of the receptacle,must be in accordance with the NEC, local codes,ordinances and regulations.• This power supply kit provides for connection of1/2” trade size electrical conduit and provision forconnection to a wiring system in accordance with theNational Electrical Code. ANSI/NFPA No. 70-1996 orlatest edition.• Use ONLY the wiring size recommended for singleoutlet branch circuit.• Proper current protection is the responsibility ofthe owner.TOOLS NEEDED• Phillips head screwdriver• 5/16” Nut driverWARNING RISK OF ELECTRIC SHOCK.Disconnect the electrical power supply before wiringconnections.GE is a trademark of the General Electric Company. Manufactured under trademark license.31-5000623 Rev. 0 09-21 GEAInstallation Instructionsfor your newRAK315D, RAK320D, RAK330DRAK515D, RAK520D, RAK530DPower Supply Kit forDirect ConnectionBefore you begin - Read these instructions completely and carefully.IMPORTANT – OBSERVE ALL GOVERNING CODES AND ORDINANCES.Note to Installer – Be sure to leave these instructions with the Consumer.Note to Consumer – Keep these instructions with your Owner’s Manual for future reference.RAK315D, RAK320D, and RAK330D kitsThese kits are for use with 230/208V AZ45, AZ65,AZ95 and AZ9V series GE Zoneline units. GEZoneline AZ45 and AZ65 series units must beinstalled with a junction box (RAK4002D purchasedseparately).RAK515D, RAK520D, and RAK530D kitsThese kits are for use with 265V AZ45, AZ65, AZ95and AZ9V series GE Zoneline Units.FOR 230/208 VOLT DIRECT CONNECTAPPLICATIONS ONLYIMPORTANT: Some local electrical codes and customerrequirements require PTAC units to be direct connectedto building wiring.These models must be installed using the appropriateGE power supply kit for the branch circuit amperageand the electrical resistance heater wattage desired asindicated in the units’ use and care manual.6HHWKH32:(5&211(&7,21&+$57WRFRQ¿UPWKHappropriate kit.POWER CONNECTION CHARTGE 230/208 VoltPower Supply KitCircuit Protective DeviceRAK315DRAK320DRAK330D15-Amp Time-Delay Fuse or Breaker20-Amp Time-Delay Fuse or Breaker30-Amp Time-Delay Fuse or Breaker*RAK315D not for use with AZ95*18 modelsFOR 265 VOLT DIRECT CONNECTAPPLICATIONS ONLYIMPORTANT: Connection of a 265V AC product to abranch circuit MUST be done by direct connection inaccordance with the National Electrical Code. Pluggingthis unit into a building-mounted exposed receptacle isnot permitted by code.These models must be installed using the appropriateGE power supply kit for the branch circuit amperageand the electrical resistance heater wattage desired asindicated in the units’ use and care manual.6HHWKH32:(5&211(&7,21&+$57WRFRQ¿UPWKHappropriate kit.POWER CONNECTION CHARTGE 265 VoltPower Supply Kit Circuit Protective DeviceRAK515DRAK520DRAK530D15-Amp Time-Delay Fuse or Breaker20-Amp Time-Delay Fuse or Breaker30-Amp Time-Delay Fuse or Breaker*RAK515D not for use with AZ95*18 models