GE SX Series Installation And Operation Manual

GE SX Series Installation And Operation Manual Manual pdf 20 page image

DIAGNOSTIC STATUS CODESSX TRANSISTOR CONTROL Page 20Revised May 2003Krusin adhesive spreader model 00031Vehicle surface after proper grease applicationSection 4.4.5 Mounting the GE Controla) Place the control unit with desired orientation onmounting plate with mounting holes aligned.b) Move the control slightly in all directions to eliminatevoids and enhance the distribution of the thermalcompound.c) Insert the all of the mounting hardware (4, 6 or 8 bolts,M6 or M8, necessary for the mounting of therespective family of controls).d) Tighten these bolts (as per sequence shown indiagrams below) to half of the nominal torque value(7.5lb-ft).e) Lastly, tighten the bolts to the nominal torque value (15lb-ft), following the same sequence.Calibrated torque wrench for hardware installation1 43 21 3264235175316824Proper sequence for use in tightening hardware duringcontrol mountingSection 4.4.6 MaintenanceIf it is necessary to remove the control for service, carefulconsideration must be given to removing the old thermalcompound from the control and mounting surface, prior toreplacement of the unit. Never re-use thermal compound.Use a putty knife or similar straight edge to carefullyremove all thermal compound residue without damagingeither mounting surface. Flush the surfaces with a liquidde-greaser or parts cleaner and allow them to dry, beforere-applying the thermal compound and mounting thecontrol. Take care not to contaminate the surfaces withhydraulic fluid or battery acid.Section 4.5 General Troubleshooting InstructionsTrouble-shooting the SX family of controls should be quickand easy when following the instructions outlined in thefollowing status code instruction sheets.If mis-operation of the vehicle occurs, a status code will bedisplayed on the Dash Display (for vehicles equipped with aDash Display) or made available by plugging a Handset intothe plug "Y" location, and then reading the status code.Note: Status code numbers from 00 to 99 are tractioncontrol status codes. Status codes with the prefix 1 (101 to199) are pump control status codes.