GE Spacemaker DCXH46 Owner's Manual & Installation Instructions

Also see for Spacemaker DCXH46: Owner's Manual & Installation Instructions Owner's manual Owner's Manual & Installation Instructions Owner's manual and installation instructions Owner's Manual & Installation Instructions

Contents

GE Spacemaker DCXH46 Owner's Manual & Installation Instructions Manual pdf 10 page image

1. Prepare the area and exhaust for installationof the new dryer.2. Check to be sure that the existing externalexhaust is clean and that it meets attachedinstallation specifications.3. Place the four corner posts from the shippingcarton on the floor, parallel to each other, 2–3″apart. Carefully lay the dryer on its left side ontop of the corner posts. Remove the foamshipping pad.CAUTION: To prevent damage, donot use the control panel as a means to pick upor move the dryer.4. Return the dryer to an upright position.5. Move the dryer to the desired location.6. Connect the external exhaust.7. Adjust the leveling legs to match the washerheight. The dryer must be level and rest firmlyon all four leveling legs.8. Connect the power supply.9. Check the operation of the power supply andventing.10. Place the Owner’s Manual and the InstallationInstructions in a location where they will benoticed by the owner.Installation InstructionsTOOLS AND MATERIALSYOU WILL NEED Phillips head screwdriver Adjustable pliers (adjust leveling legs) Carpenter’s level Flat or straight blade screwdriver (may be neededfor cord strain relief) Duct tape Rigid or UL-listed flexible metal 4″ (10.2 cm) duct Vent hood 1/4″ nut driver (remove terminal block accesscover and install cord) (ELECTRIC DRYER) Pipe thread sealer (GAS DRYER) UL-listed strain relief (may be suppliedwith cord) UL-listed 30A, 240V, 3-wire, #10 AWG minimumconductor power cord (U.S. existing structure) UL-listed 30A, 240V, 4-wire, #10 AWGminimum conductor power cord is required(U.S. new construction) Flexible stainless steel or plastic-coated brassconnnecting tube (if allowed by building code)(GAS DRYER) Open-end wrenches for flexible tube andconnector (GAS DRYER)PREPARING THE INSTALLATION SITEAND UNPACKING YOUR DRYERFoam shipping padBack ofDryer10Packing