Automatic RoastingAuto Roast uses the temperatureprobe to cook to the desiredserving temperature. UnlikeTemp Cook/Hold, which uses asingle power level, Auto Roastw up to 3 power settings whichautomatically switch duringroasting, thus providing even,tender cooking results withoutovercooking.Just as in conventional roasting,only tender roasts should be AutoRoasted until specified internaltemperatures are reached. Lesstender roasts should be microwavedby time, according to the cookbookwhich comes with your oven.~eparing Roasts forAuto RoastingPlace tender beef roast in cookingbag on trivet in microwave-safe dish.(Refer to package instructions forproper use of cooking bag.) Insertprobe through cooking baghorizontally into the center meatyarea not touching bone or fat.Make sure the handle does nottouch the food or top or sidesof the oven.Place pork roast in cooking bagand place in microwave-safe dish.Note: By touching the AUTOROAST pad during cooking, themeat’s internal temperature will bedisplayed. (“COOL” will bedisplayed until meat reaches 90°F.)When uad is released. doneness1 code r~appears on the display.I/ codes 1 o; 2, the oven signals withPlace meat in oven with ~robe to 4 beeps and “TURn” flashes on thethe right. Insert cable en~ of probefirmly into receptacle on oven wall.How to Auto RoastBeef Roast to MediumHu I UIVIHI I1. Touch AU~ ROAST pad.“ROAST” appears on the displayand “ENTER CODE” flashes.Touch number pad 1. “l” and theselected doneness code—in thiscase, “MEd’~ appear on the display.“CODE” flashes. After 4 seconds,“START” flashes on the display.Touch START. (See “Auto RoastGuide” on page 13 for completelist of recommended codes. )display when it’s time to turn theroast over. After you turn the roast,close the door and touch START.(Note: Oven continues to cookafter the signal whether or notroast is turned over. )3. After a pre-programmed foodtemperature is reached, oven beeps4 times and “HOLd” appears onthe display.4. Food will be held at thistemperature for 60 minutes. Theoven then beeps 4 times and “End”appears.12