HOW TO OPERATE YOUR WASHERFeatures and appearances may vary slightlyWARNINCr-To reduce the risk of fire, electric shock, or injury to persons when using yourappliance, read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance.Regular0 0_v a* _TOMAn_nEN_W,_RMCOW MEO PUS_TOCOLD HOTCOL OLD SMALL • L_R_E0Spacemaker LaundryWASH_INSETemp Load Size Start0 0Auto-TimedSee How to Operate Your Dryer section for the above Dryer controlsSetting the ControlsUse the Suggested Fabric and Cycle Settings guideto help you make the proper selections.O Select Water Level.SMALL: Washer is less than 1/3 full of clothes.MEDIUM: Between 1/3 and 2/3 full.LARGE: Over 2/3 full.For best cleaning results, the load must be able to movefreely in the water. Too big a load or too little water cancause wear or tear of load items.Select Wash/Rinse Temperature.Push Cycle Selector knob in and turn clockwise toyour selected wash setting._1_ Pull Cycle Selector knobout to start the washer. Ifyou wish to change settingafter washer has started, pushCycle Selector knob in to stopthe washer and reset to the newJ_ _'_ 22r /STOp_ _lposition. Setting can be changed at any time.Washer Lid LatchFor easier loading convenience,use the washer lid latch.To hold the washer lidup, lift the lid until itsnaps past the latchunder the control panel.To release the lid, pushthe lid latch up. LID LATCHTo Add Items After Washer Has Started• Turn off the washer.• Latch the washer lid.• Add any additional articles by submerging them nextto the agitator.NOTE: When washing stockings, panty hose andother easily tangled items, always handle separately.To minimize tangling, we recommend the use of a netlaundry bag.How to Soak in Your WasherAllow the washer to fill and agitate for a few minutes to dissolve thesoaking agent. Then push in the Cycle Selector knob to stop the washer(keep lid closed) and allow to soak for as long as desired.After desired soak period, pull out Cycle Selector knob to complete cycle.6